Recent content by elcie

So finally the ARP clutch bolts turned up from USA after snapping an OE one in the flywheel, I ordered ARP ones as they have a normal hex head opposed to the Renault that are torx, New genuine Renault flywheel bolts. Used some 270 loctite on them, Engine is now in and with the ti heat...

Slow updates, even though the car is in the garage Its an hour away from home so finding time is hard with studying an apprenticeship and college work. Went to Autosport back in Jan though, great event, any one that hasn't been needs to go next year! I know I wanted a few bits and its a...

Some parts back from the powder coaters Gearbox engine mount Engine mount cover Inlet manifold And a few other brackets, not going to mad as you won't see most things and still want the car looking O.E, these cost £100 as it is. Really pleased with the results, so much better...

Ds1.11 like you said, sounds like a winner, I love them, yes they are expensive but I can't falt them and should you really buy cheaper brakes just because they are cheaper Also where did you buy your seal kit from? Thanks

So being 6ft tall, I find with the seat far back, the steering wheel feels a little stretched with the harnesses on, I see this neat spacer a guy in Monza, Italy the he had made up to retain the standard wheel as we want to keep the controls and clubsport look, please get in contact with him if...

Hi Russ, I've only seen them on eBay from that Ro fag guy that sells loads of genuine renault sport stuff, there aunt cheap and I'm almost weighing up just buying new arms and keeping these as spare, £75 EACH plus £10 postage...

The car had it in, but my brother had an Alien green 200 before as yes it felt different but, different not really any better or worse just feels like a deferent car. This grey one handles well enough with just the springs.

So after striping the car down, found a few ball joints could do with replacing, they weren't to bad but rather do them now, Lower arms, dropped them off at a friends work shop, the lower ball joint that goes into the hub screws out with a bit of heat a punch and hammer, new OEM ones to be...

This was a Pistonheads sunday service at Silverstone earlier this year, Jack my brother took the car as I was away. In the McLauren tiled garage at the start of the day....... On track with some M3 friends And the number plates Dirty end to the day

Stick attached to the passenger head rest upright bars then like a handle bar mount get good views, cable tie or jubilee clip, and some people I've seen pull down the inside light and hang it from there

Just ordered these. We were after a good quality wheel stud to replace the current bolts, first off the bolts are a pain to line up with the spacers and second they have seen a fair amount of work, some people say you should replace every season due to the stretch and strain they are put under...

Yeah its quick enough on the roads not many things get away Yeah just buy giant coins made by Velco' of eBay to stick them on with like here This was early 2016 at Snetterton, the car was still so good in the damp/wet conditions, the traction control system works so well pulling the car back...

Goodwood

Snetterton before the cage and seats

Thanks everyone