Recent content by Flam686

It’s a wired one, hitting a limit in 4th & Fifth gear at 5.5k ish, temp light comes on Momentarily but then goes out after a second or two, other gears are fine to 7k changed temp sensor and have bought replacement standard thermostat to try also, had PMS low temp one in for 2 years with no...

Anyone got a CLIP system around Reading ? Trying to diagnose rev limit issue on PH1

Ok cheers, will try an check all connections, what app or system would I need to datalog ?

Chan Replaced it but no difference. Before I get the map looked at are there any other obvious sensors that could be causing this ?

ok thanks, will replace

I have a strange issue where the car appears to hit a rev limit at about 6k in 3rd & 4th gear, it’s like it hits a wall and is pulled back and the temp light comes on for a couple of seconds but the actual temp is normal. All other gears rev to 7k without issue. As a race car I have to short...

Hi Guys, I have what I think is probably a cracked or damaged gear Selector enclosure as there is a lot of play in the stick and it doesn't go into 1st very well and seems to catch from 3rd to 4th. I want to tighten up the sloppiness first of all and go from there before looking at the box to...

All sorted

anyone got a set or rear wheel spacers anywhere near Snetterton ? 5mm per side

Ah yeah of course thanks

if I wanted to change my front discs, would re-using the long studs be ok. IE to press them out and back into the new discs ?

172 Ph1 race car Finally got my lower mount bolts out and when trying to fit the GAZ gold, with the lower mount collars fitted (either side of lower mount spherical bearing, the spring touches the inner side of the wheel well. I could try and cut 5mm off the inner collar but that would put the...

Cheers that has done the trick nicely

Replacing rear coilovers. put penetrating oil on over night and manual method with long pry bar wouldn’t move and my impact driver wouldn’t touch them either. I am thinking heat is now the way to go but wanted some advice as don’t want to snap them. Apply via heat gun to bolt heads or blow torch...

Thanks NLC Yeah makes total sense. Will get some coilovers