Recent content by jackherer

It is possible to 'programme' the remotes but it involves a soldering iron and adding/removing links as they are very primitive! - http://laurent.deschamps.free.fr/plip/plip.htm You can sometimes find a matched remote and receiver on ebay, all you have to do then is plug the receiver in and...

That looks very nice apart from those floor mats, they've written '205' using the later font used on 206s etc. There is someone on the 205 forum who will modify your lock barrels so they all work off a single key - https://www.205gtidrivers.com/forums/topic/171523-lock-modification-service/ You...

Thanks for that. I was hoping it would be different to autodata but it is probably where autodata actually got their info in the first place. I wonder if a mistake has been duplicated by autodata and haynes? Has anyone actually checked the continuity of their abs sensors and found the diagram to...

I read your thread saying that when I was searching actually. You can't blame the solus for that IMO, I hate to say it but that is operator error really, if it is showing an impossibly high speed it means a high frequency signal is leaking in somehow, it can't possibly be caused by a sensor...

Thanks. I've looked at the live data on my snap on solus pro and I can see wheel speeds increase when I spin the three good wheels but nothing when I spin the offside front.

I've been looking at Autodata again and it does actually have variations on the diagram for different ages of car, they're on some tabs that I missed earlier. However the diagram I was looking at is for models made up to May 2000 so it should match the car, the next one covers June 2000 to...

This is the wiring to the controller plug, the top row of pins start with 1 on the left and these are the connections I'm seeing: 1+3 offside rear sensor 4+5 offside front sensor 6+7 nearside front sensor 8+9 nearside rear sensor Haynes and Autodata both say: 1+2 offside rear 3+5 offside...

I'll get an oscilloscope on it tomorrow to see if the signal is actually reaching the controller plug intact, it's only two wires so if the signal isn't getting that far or is distorted I'll cut it all out and replace it with new wire all the way end to end. The problem I have is the...

The lights turn on immediately and solidly and the fault code returns as soon as I erase it.

It looks OK and the fault code returns without even moving the car and I don't think it could detect a fault with the ring until the wheels turn.

I'm trying to put the ABS light out on my friends 2000 X reg Clio II RS 172, reg X459 DYB which seems to have been owned by a few members on here in the past. The ABS light was on when he got the car so I don't know all the history. I read the fault codes and the only ABS code is showing a...