Recent content by JakeyA

Obv not alot of difference between 22 & 23 outer but 22 or 25 for inner is huge lol

I have 25mm inner and 23mm outer bushes They also list 23mm inner and 22mm outer

is there anyway without measuring to see what size front arb bushes are fitted? Markings or part numbers on the arb? Powerflex list 2 sizes of inner and outer bushes... knowing my luck the ones i purchased are the wrong size Ta

@JB21 Done a buy lol Gen cup dampers Cooksports Solid mounts Pms brace All 150miles old

Nice one... more scrap skip fodder then 😂:up:

Tar sound deadening weighs... well an absolute tonne lol! You'll be suprised

just rebushing and cleaning up my rear beam Not sure but i think it already has camber shims...opinions?

Cup had 5mm thicker rear stub axle bases/mounting flange aswell "apparently" Is that where it gets the camber from of is that a cup spec rear beam?

so i asked this in the interior section, but been advised to ask in here Does the metal frame inside the dash actually need to be kept to brace the steering column mount? Ive cut away some of the passenger side, just keeping the bits the lower dash mounts on. I notice the drivers side section...

Jeez.... did you buy the car from the bottom of the sea? Thats extreme 😊

https://www.ebay.co.uk/itm/152505175290

seam to of found a decent alternative to powerflex back bushes Nolathane Black bushes Found them on ebay but they do have a site aswell Look well made , come with grease and a couple of key rings lol £29.90 delivered Shame they dont do the fronts!

Kwikfit usually have hunter 4 wheel alignment machines Sometimes they do a free inital check and then charge per adjustment

Not anymore. Had same convo with them. Apparently they have supplied loads of the ph2 ones and had no issues on 172/172cup/182s These are the same spec as what they supply for the ph2 https://www.ebay.co.uk/itm/401189332175

other than to give the lower dash somewhere to mount to.... does the metal dash frame actually do much. I know it bolts up to the steering column mount but does it give that much actual support? I am still running a dash, be it with a very stripped down and lightened lower section Ive...