Recent content by quiksilver.cm

Legend! Thank you..

@JamesBryan can you send me it too pretty please 🙂

Where did you order the megane pulley from?

Exactly, last year I ran 156bhp and this year I’ve now got 142bhp. Somethings not right with these runs. Have you spoke to Stewart about going to AET Motorsport to get your power figure instead?

Did you’s have a power run at donnington too?

The only thing I noticed when mine was dyno’d is that the hub dynos seem to vibrate a hell of a lot. To be honest I don’t think they’re the most accurate of dynos as teams had similar problems like this last year, getting power readings well out of the norm. Teams that were in class B in 2017...

I popped over after the shoot at dinner time. (It was me that helped you push your car back into the garage) I had a quick look at your car and seen you were busy ?? I had a good day but only got a 142bhp power test this year for some reason. Did you get yours tested again at Donnington?

That’s a good power test! I got 156bhp last year for my power test. ( I also have a stock engine) I’m at Donnington Park tomorrow too so I’ll try and pop over for a chat. I race in TDT.

@SafetyDevicesDaniel Any pics of the tab you cut out of the dash bar

Ah Ye I think it is.

Looks good, harness bar is better placed.

@SafetyDevicesDaniel Does this bolt straight through the floor as the last cage bolted into the captive nuts in the feet

If you look at the pic on safety devices website of the unpainted cage, the rear double cross and harness bar are totally different. It actually looks correct in this pic

Hyperhatch has the steering column support bar been cut to fit the front drivers side 'a' pillar leg? From your pic it looks like it's been cut. In the second pic you can see which bar I mean

Thanks, what Clio did you fit it to? 172 ph2?