Recent content by Tr3vordm

Track car but road legal, trailer seems like a good call. Car currently @markfishy awaiting its prep for September Brands hatch shakedown

I have the same @JON FOZ subframes and Corbeau clubsports. Initially had some difficulty lining up the side mounts so took them off the seat (I have the standard with seats which are very snug) and fixed them in first to the subframes. I have used the sliders also and once everything has been...

@smith647 - yes going to be a interesting job removing the sound deadening material which is hard as nails - think the blowtorch might be needed for a bit of softening first.

Thanks guys, think I may need some spacers to increase the height of the seat slightly buy at the car is up on ramps having brakes, starter motor and all sorts of other bits changed it hard to tell - either way round sliders going !

I've not driven the car with the sliders on yet but will remove them and fix the position if they are moving around.

No problem Jon, I could not find any install pictures with your frames so hope this helps & feel free to use them. Managed to get the seat / frame combo to fit without any alterations - very pleased.

Preparation works have begun to ready the car for some track day play. I will admit that I am completely new to the Renault scene but becoming quickly addicted to the preparation works - my bank balance can also vouch for this! Car is stripped awaiting roll cage installation by @markfishy - if...

All I know is it's tight! I've got to change another starter tomorrow so going to undo the manifold and see how it goes - let's hope the bolts undo and the gasket re-seals

The heat shield wont go into position with the starter motor bolted tight - needs to have some movement in order to slide it past

Heat shield tip Work from above and below car. 1. Small amount of Spray grease onto the heat-shield clip 2. Put starter motor in position and loosely do up the 3 bolts so the motor still has some play 3. Connect up electrical - spade connector then loosely do up main terminal but don't fully...

It can be done without dropping the manifold or removing the battery. You need to get under the car to get full access, jack up and put both front sides on axle stands. Disconnect battery first 1. Take off under tray 2. Take off air box 3. 13mm socket set 3/8 drive + extension bars 4. Remove...

Hi Jon, can you confirm price for the subframes (passenger and drivers side) please. Many thanks Trevor