Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Jacked the car up today and turn't the wheel and span them but i can't seem to get the ticking/clicking noise had a good look underneath and can't see anything touching/rubbing to cause the sound.
i only seem to get the noise when out driving on certain locks when turning the wheel
So will I require the two piece J&R shaft on my 182 cup pack? Can you buy genuine driveshafts from the likes of Renaultparts direct or Renault Wolverhampton ?
Bolts are tight it also has grub screws but they are flush. It was only clicking when turning left but recently it's clicking both sides now. Is it worth paying the extra for Shaftec driveshafts?
Hi all
Can anybody point me in the right direction iv noticed recently when turning left or right at low speeds in 1st gear I'm getting a clicking noise from outside the car iv only noticed it at very low speed such as pulling out a junction slowly. Anybody experienced this before?
Thanks in...
That is stunning mate. So took the 10mm spacers off today and going to run the 5mm seems to be okay i still think even with 10mm it would still arch out slightly :(
I don't sorry im away from the car for a couple of days now! Do the H&R springs lower the rear the same as the Sportlines? I'm not sure if i should run 10mm or 5mm on the rear now as the front is 20mm don't want to look odd :-/
Hi All
Had some 205/45 tyres fitted today and noticed my rear it's arching/scrubbing when going over uneven ground. I have 16" ET40 Turini's with 15mm axle spacers if I swap them for 10mm axle spacers will I still have the arching/scrubbing?
I used to run 195/45 tyre so never had an issue.
Thanks
After taking it all back off I noticed marks on the hub where the wheel bolts were just a little to long, found some shorter ones in the garage and happy days it's sorted.
The Wheels are Speedline Turini ET40 16"
http://www.europerformance.co.uk/pages/products/product_info.mhtml?product=423513
^^ link to spacers didn't buy them from this company tho
Thanks for the quick reply.. Think il take them off tomorrow and re-fit and check in that order. Would my wheels need balancing again because iv fitted wheel spacers?
Hi can anybody shed any light.. I fitted some 20mm H&R spacers bolt to hub then wheel to spacer after fitting them iv noticed I'm getting steering wheel wobble on the motorway from around 60mph upwards. I recently fitted brand new wheels and tyres all balanced before I fitted the spacers if...