Search results

would i be right in saying if there was a missing spacer that the discs would have wheel bearing type play in the wheel when pulled?

Re: mintys 172 turbo Yes, I time has no value it was for a friend. mates dont charge :)

Re: mintys 172 turbo 3k for 230bhp JESUS CHRIST! Weve just done our mates £1900 = 340Bhp :/ never the less great car and looks well done

Who cares. What others think just do what you want. Booost

Yes Jordan. Can you hell with that?

Il get you a photo tomorrow.

I bet some ones taped the engine light

Defo no little light flahing fast?

Yes either take feed off coil pack or rear of clocks, tap into the wire that lights the oem light ip Up

5 two over shoulders. Two by side. One up your crotch area 6 two over shoulders. Two side Nd two crotch Personally prefer 5

Souds like its the speedo pick up on the box, cheap enough check the plug on it also

Awsome that's the one

Was 19 when i got mine in 30 now on and off

I used to have this but i cant find it. Im after a diagram of the 172 clocks too see what each wire does on each plug. Thank you

Better be carefull what i post i may get wrong.

Pmsl. Mick admit it mate uve got matching gear stick

Sorry i ment open loop always get muddled id as chip says have things like that installed before

Here here diamond

Pmsl at this thread! Good luck

i wouldn't bother with the Lamb, if its mapped correctly and ran in closed loop it should be fine. ive nver ran this as always had a Wide band fitted tho

Re: AndyRG - Opps ive done it again! Let the Turbo build commence!!! :)

Re: AndyRG - Opps ive done it again!

its around 220Bhp, Will be dynoed when we finish mapping, few little things to iron out, :) Awesome little car :) goes really well i cant wait for next stage ;)

Re: AndyRG - Opps ive done it again! the whole point of this car unlike the others ive done is it be a little less in YA FACE :@)

Re: Clutch fitting..alignment tool doesn't fit in flywheel +do you need to lock it of I use a Draper alighment tool, it looks crap but works well, the friction plate shouldnt move about, you need to ensure its aligned and does not move. Tighten the 11mm bolts corner to corner if that makes...

Re: AndyRG - Opps ive done it again! few photos from camera i have painted my Cup spoiler! but i dropped it while fitting FURIOUS :( but managed to get the Cup washer jets sorted

Chris be nice to see you then :)

Re: AndyRG - Opps ive done it again! Whats hers is mine and whats mine is mine :) Matthew young man, you know im always on my toes ;) The Engine is already in design stage :) Soon to be mate

use a copper hammer;)

Im sorry what parts are you using?? I have uses FIA, QH and various other run of the mill brands and you always get all new bolts with time for about £8 each