Search results

Yeah good shout I will try that, cheers!

It's not a standard part mate it's definitely a specialist part they're normally used to secure induction kits in the engine bay. I was just hoping someone would be able to tell me where I could get one.

First of sorry if this is in the wrong section I wasn't quite sure where to put it. Basically I have been driving myself crazy searching for this type of jubilee clip it's just a normal jubilee clip with a threaded bar attached to it like this. Apologies for the crap picture, if anyone...

Just make your own wiper blank it's easy just some plastic filler sand it flat and paint it. It won't affect the automatic wipers.

451

The only worry I would have about setting up a shop for detailing supplies would be the size of the market you would be catering for. If you can get the shop free of charge then that's ok, but you also have to factor in the cost of stock, running costs VAT etc.. And also are you going to be able...

Get a length of wood rest it against the back of the disc and smash the shite out it from the back.

Yeah replace the door check strap with a new one, not too bad a job just had to do it on mine.

Though I will admit that that looks f**king awesome.

Got to be a 172 cup best ones by far ;)

513

If it helps I just sprayed mine with some silver hammerite and they came up like new.

Try some polish on it see if that helps.

Front ones you need to jack the car up to get to the seat subframe bolts under the car. There should be four rubber covers you remove and then undo the bolts with I think it's a 13mm deep socket. The rear seats you just have to pull up the bases and they come off and the upper part will be...

Managed to get a couple of hours on a mates ramp yesterday so I could fit the front calipers and change the rear pads and discs. plenty of meat left on that one! Probably going to put it on ebay as part worn. Wasn't too sure about the gold on the calipers but now they're on I think it...

Yeah the 21st is good for me as well.

I may be up for this if that's alright it would be good to meet a few people from here!

Just a few updates, got rid of the harnesses and replaced them with a leather rear bench and also changed the cloth door cards to Alcantara ones. Also gave the wheel bolts a coat of paint as they were looking terrible. Before After Then decided I wanted to refurb my calipers as they were...

265

Yep I think mine ran 180 something on the rollers at Rs Tuning it is a freak though.

http://www.spray-shack.co.uk might be a little out of your way but they do have a very good reputation.

There must be something wrong causing extra stress on your rear wheel bearings. I would have it checked over on a hunter alignment system it might show any obvious faults.

454

What are your questions?

Have a look in my project thread I made my own wiper blank it turned out not too bad

Were you in yatton last Friday I think I drove past this? Looked good if it was the same one.

BTM's exhaust has a new design which gets rid of the crap renault exhaust mounts which will save you a lot of hassle in the long run as they fail frequently so I would look into that if it was me.

Just to add to that when I bought my cup it came with a set of toyo proxes 4 on it and they seem to be a lot better but if he is looking for a tyre to use on track I would steer well clear as neither of them will be up to the job.

I put a set of t1r's on my ST great in the dry total shite as soon as it rains though IMO.

Another vote here for the 3m kit, used one on my old 182 best £20 you will spend on the car!