Search results

Went to click wipers onto 2nd speed today and they just continued wiping at the normal speed, is there a relay which controls the 2 speeds? Sent from my BLA-L09 using Tapatalk

Can I fit aftermarket rears on their own? I have the standard fronts fitted. Sent from my BLA-L09 using Tapatalk

Anyone used these springs from ebay or know if they are any good? Sent from my BLA-L09 using Tapatalk

Anyone had experience of these? Sent from my BLA-L09 using Tapatalk

Have been replacing the jubilee clips on my CV gaiters with the crimp type but am now unsureif I have them ( the gaiter) fitted correctly. It feels like the rubber gaiter has a lip on the inside which is locating in the outside diameter of the CV joint. Am I correct in thinking this? Sent from...

Cannot remember what brand they were Sent from my BLA-L09 using Tapatalk

Does anyone else have this, new steering arm gaiter on my Clio has started to crack at the small end after less than a year on the car, also put new gaiters on my mini less that 2 years ago and these have cracked too. They were not cheap ones either Sent from my BLA-L09 using Tapatalk

Thanks mate, will try ebay Sent from my BLA-L09 using Tapatalk

The bit with the electrical contacts that you push the bulb into and which in turn pushes into the headlight housing. Sent from my BLA-L09 using Tapatalk

This sort of thing? Sent from my BLA-L09 using Tapatalk

Mine have gone brittle and have started to crumble apart probrally from the heat have been looking on eBay for replacements but I'm not sure which to use, anyone know? Sent from my BLA-L09 using Tapatalk

Your correct I have not, these all VW / Audi too? Sent from my BLA-L09 using Tapatalk

Just noticed this on the blower resistor connector. Don't think this is normal?? Sent from my BLA-L09 using Tapatalk

Elongate the hole in the clamp, helps align the bolt into the thread earlier. Sent from my BLA-L09 using Tapatalk

Just been eying up the 6 line set!! Sent from my BLA-L09 using Tapatalk

Look on their website https://www.prolinemotorsport.co.uk/renault Lists a load of different sets Sent from my BLA-L09 using Tapatalk

Can't seem to find them now?? Will search again. Sent from my BLA-L09 using Tapatalk

Cleaned and polished the 182. Sent from my BLA-L09 using Tapatalk

Thanks. Sent from my BLA-L09 using Tapatalk

Can anyone confirm the size of union needed for stock 182 calipers, I think it's 10 X 1mm?? Sent from my BLA-L09 using Tapatalk

Great, will get a set. Sent from my BLA-L09 using Tapatalk

I have also been searching eBay Would these fit? Sent from my BLA-L09 using Tapatalk

Nice one, thanks for the link Sent from my BLA-L09 using Tapatalk

I have circled the hose in question Sent from my BLA-L09 using Tapatalk

The ones that come from each rear caliper and connect to the main line Sent from my BLA-L09 using Tapatalk

Where can I get a set of these hoses from? Sent from my BLA-L09 using Tapatalk

Notice that my rear brake lines are looking crusty where they clip onto the rear beam. I have seen some posts where the steel pipe has been replaced by braided hose? Is this preferable to copper pipe and what do I need to do it? Sent from my BLA-L09 using Tapatalk

Jurist?? Should say Kurust. Sent from my BLA-L09 using Tapatalk

Have been under the car this morning tackling some corrosion on the underfloor. It has appeared in the same spot on both sides of the car in the small triangular section just in front of the springs. Scraped, jurist and waxoyled now so hopefully should be good for a time. Has anyone else...

Great, only had a new clutch last year. Sent from my BLA-L09 using Tapatalk