Search results

hello friend , nice project, send me the original file from eprom 95160 from ECU , and i will help you with virgin, renolink comand ECU virgin doesn't work.

Hello, can anybody tell me if 182 with grup N timing EFI remap , 182 exhaust and cat will pass MOT?

pin 6 is only for autoclosing when you close the windows from your remote keycard ( 2 press on lock button) . maybe your motor windows module it;s dead....

Hello, if your TPS is 3 wire only you need only 1 potentiometer like 1 5 6 or 4 2 6 check the wiring with a multimeter and with ignition on and you wil have 5 V beetwen 2 (+ ) an 6 (-) and the other 2 wires will be Signal from potentiometers. (1 and 4 )

it clips the 2 power steering hosses , and it's monted with a screw on ECU bracket

horn or intake bypass valve

You need to change the complete steering column from the car you take the immobiliser kit. Error code 168 it's the steering like i said.

The car will not turn over until you change also the steering column. The steering column it's also a part of immobiliser kit on clio mk3.

White one it's for cruise control button, and grey i think ESP button

Hello , what year is your R26? there isn't no fuse and no relay for fuel pump , the relay is inside the fuse box next the battery and you can not change it. Check all the connectors inside that fusebox and the connector to the fuel pump. the video is for 2003 - 2006

Hello ,the fuel pump relay is 236 see the schematic Engine ECU.

From what i see in your erors there is a problem with the throtle body,, like other say check the connection on throtle and on injection computer, and the wires I most cases the throtle is bad , change it with one that you are sure that it's working properlly. You can use any throtle from...

You have a problem with the supply on heater resistor for both lambda sensors , so you need to check if you have 12V on lambda sensors. For that measure between both same colours wires from lamba with a multimeter with cold engine started.

Search FNR Key Prog 4 in 1 Key Prog For Nissan Key Prog/Ford Key Prog/Renault Key Prog on ebay , and you can program yourself.

Hello , you need to supply the motor with + !2V on pin 4 , ground on pin 3 , to move up put ground on pin 2 , to move down put ground to pin 1.

Disconnect the battery . Use a brake cleaner spray to clean. After cleaning ,on the first start the RPM me be higher but after some miles will be ok (750...850 RPM) .

You need to clean the throttle body.