Search results

I remember reading the new member thread.. you are doing a fantastic job here, I wish I had your garage! Fair play for taking the time to photograph, upload, post a write etc as well on top of all this work, it does take a while to do! Good job anyhow.. a very nice Cup!

I found your pinout in another thread.. I'll copy it here also, even though it's PH1 it was hugely helpful when needed at short notice :) Thanks pal

So... continuity on the cars plug to dials, both left and right indicator pins beeped on the multimeter, with the hazards on got intermittent beeping as the exterior bulbs lit up... all fine! Measured voltage... both reading well on and off when the lights are going... all fine! So connected...

Right.. clocks back out.. multimeter on the plug, continuity setting, pin 3 positive, pin 24 earth.. nothing... Tried a battery and some wire on the pins and it lights up :) also tried Pin 2 and the other indicator also works... so both indicator bulbs light up from the plug on the back of the...

From memory £30-40 ish? best asking Dan directly though :)

Ah the grey plug you mean, on the right like these clocks? Pin 3 being the top, third one in and so on?

Which 30 pin connector are we talking about here Calum? Under bonnet behind battery one?

Street, Somerset.. unless you plan to attend a meet or something, that's what I did. Or.. go to Renault or specialist with the software

The Clio has had this for a while now, the left indicator dash bulb stopped working around 3-4 months ago. Today I went about sorting what I thought the problem was. The indicators (left or right) work with no issues on the exterior of the car (Headlights, Rear lights, side repeaters). The...

Have you got a spare key to get another immobiliser one cut then get it programmed? If not then yes, probably easier to buy a new lock/ignition etc etc set but may also need some sorting out

I checked / replaced almost everything in the hope of clearing my light.. Dan found and cleared it before I could even notice him in the car.. get it plugged in everyday with airbag lights mate :)

My Clio revs to that lol.. It needs more! Sound reminds me of a chaved up Mitsubishi FTO :S

Am I the only one here that thinks it needs to rev more ... ?

Welcome.. ! Plymouth seems to be liking Clio's lately... ;)

Great read this thread.. ! Good to see peoples commitment also. I know someday will come where I will end up in something diesel/estate/VAG etc over the Cup, and when it does I'll have to take it to my garage and get building up my Renault 5 GT Turbo again :) Can't imagine selling my Clio...

That's what I did, fit the system properly with rear bumper removed, fit the bumper the best you can and mark it, then remove and refit again and again and again, be patient and use your dremel or similar to make it good, takes a while to do though as I did very little at a time

Seeing Clio's continuously becoming this cheap makes me sick lol ..

Seen this a couple of times a while back, used to be another one that had some huge air feed in the side of the bumper also but unsure if its the same one

Ha, shame we only had one little blip onto the motorway really but felt bad leaving the Twingo !? I did think half way back, hmm MPG isn't enjoying this constant 4,000rpm and I bet this is stressing your box a little bit. I defiantly couldn't use mine on the motorway a lot.. however that Trophy...

Seemed fine on the drive back last night ;) I like this car

Looked showroom yesterday.. needs to be sat in a Renault dealership with a machine polished floor lol

Sorted ..NO MORE AIRBAG LIGHT AFTER 7-8 MONTHS..! :DThanks SJM ;)

I have my laptop upside down

Dan ?? :S

PM'd you Dan ;) legend

I bought a Campus just for the plastic separate section of the dash!! Lucky b*****d !!!!

With 110% ... Or a Trophy one but they are even more ridiculous £££££

Bumping this because this remains and I also need it for my Clio Dan is quite a journey away for us, an all day event and trip for not a huge job. Renault are absolutely useless and keep saying it cannot be done but then decided it could be and booked us in on a Saturday, which after 10...

Jack up each side and spin the wheels and see if any sound / feel rough for the bearings. Should be silent

Dat fase 1 doe http://www.youtube.com/watch?v=fQeYRVIMYwM