Search results

I personally love the handling on my trophy with the northloopcup rcl kit on. Combined with the gripper diff its turn in and press the a pedal. Still wonders about a bit on the roads with toe out but thats par for the course.

Yep any mk2 ph2 airbag ecu will do and reprogram to suit.

You can have airbag ecu connected and no airbags configured or connected and light/servlight works good, saves multiplex issues and xmas tree dash. Had it setup like that on my old Kangoo 172. Any clio2 airbag ecu will work OK, cheap used out of a povo spec will be fine.

Scrapped sadly as he had to get rid of it as no storage when they moved out of the old nocturnal developments lockup, must be almost 20year ago now. I still keep in touch with Haz hes still kicking about and modifying the renaults.

Still got my Extra. Haz started making a pickup with his, long time ago now!

Immobiliser light is solid so its not recognising key. Needs plugging in and diagnostics with clip see whats going on.

Ive been in touch with Chris and ive fed back the datalogs, ill flash the ecu with updated map with mpps and go out and do some more datalogging. Id pop down and get it sorted but its hard for me to get over in the week as 2.5hours away. Could wind some preload off actuator but it will change...

Updates. Had the Kangoo in at EfiParts a couple of weeks ago for mapping. Strapped on the dyno. Old map was quite far off and boost was going to the moon so couldnt do a run up without tuning. Chris got down to business and started dialling it in. Seen low 300hps straight away. Few runs in...

No coding required luckily. I replaced the full lot for 2nd hand wasnt expensive. Find out what the issue is first as yours might be totally different and very easy fix. If you were closer id have a look for you mate.

Cheers mate. Racevan 3 is eating into my bank balance sadly :LOL: Oem renault pump is similar price new over here, very expensive. Id just fit the fuel pump if no aftermarket availability in SA, it will go again. Maybe ultrsonically clean the sender if you have access to one. Is it a mk2...

Replaced it on the kangoo. It was part of the full door latch on that.

Been following updates on insta and good to see its about there now after all the work. Still dont miss my old tungy. Prefer looking at them these days. Extra van still fills that c1j hit when i need it though.

Clip is good can see exactly whats open on the live data. Not sure on how the door solenoids are set up on twingo, but i had a problem with the Kangoo and the latch was knackered on drivers side which caused similar issues. If it has door switches like clio2 you could remove one by one and...

The sender has a non replaceable filter inside id be tempted to change the full unit with it being that colour, its prob well past its best, new full aftermarket sender not expensive. If you really want to change the pump you need to take the bottom basket off. If you lever it off with a...

Spot on ill get one ordered. I thought the same great to chuck in the car and will save dragging the compressor out to check tyre pressures.

Looks spot on, will be mint when done.

At a guess wiring check loom for continuety through the a pillar

Its sensing a door is open. Stick can clip on it and it will say which one is open.

Im looking at buying a milwaukee m12 inflator. Look like a good bit of kit.

My tungy gtt seemed to be going from super reliable to fix carb issues every drive. I had to clean idle jet before it left with new owner :LOL: he didnt have no issues typically but maybe i was a bit more switched on with it. In comparison my extra van on efi just runs well like efi cars do.

I dont use scan tool. Depends on what car your using it on, i usually do the mutiplex scan and select ecu thats relevant. Every model of ren seems to be slightly different in approach and whats available on the menus.

Whats the verdict on old engine dying, worn out or oil starvation?

Be prepared to fix the gtt a lot more than the clio mate thats my only thoughts on it.

Id get geared up with a laptop to suit, only need a cheapo. You will need to be in the ecu at some point

Does gen90 have onboard datalogging? Most half decent ecus have something. If not just watch live coolant temp data on laptop and check fan cuts in. Also most ecus say fan is active when its on.

Do some datalogging to see what temp the ecu is reporting, where fan is cutting in and out. Ive no idea how accurate ph1 oem temp gauge is, ph2 is not very accurate. Unfortunately id say the smaller rad and fan combo is the issue, ok for a short period in traffic but not good in longer stints...

Fan will be controlled by ecu as per oem. Shouldnt need an override if it works right, how hot does the coolant get in degrees? Is the fan adequate sized? I had a small spal one on my turbo trophy which worked ok on cooler days, but was no good on hot days and temp used to steadily creep up...

Sad to see its sold as great looking clio. Fighting the rust and old car stuff when using as a daily driver can get tedious and time consuming, these are more weekend/occasional use cars now. Keep us updated on the next project.

Send uch away for repair. Cheap enough, theres a company that repairs them on ebay.

New headlamps look spot on. Nice and fresh.