Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Installing my extinguisher over the weekend ahead of my first race in the Tricolore Trophy next month.
I have a 5 nozzle system meeting the new regs of tech list 16. Nozzle locations are clear.
However, I was planning to route the pipe near the rear washer bottle hole in the bulkhead, then...
This has left me scratching my head.
With the ecu ‘present’ I reset everything to ‘without’ whilst all sensors/airbags were disconnected.
Then disconnected the ecu, set it to ‘missing’ on the UCH install list. Ran a multiplex test and no faults found; ie no ‘airbag ecu not found’ fault...
I’m installing an oil cooler in my low pressure PAS line, due to a Cadwell almost killing my pump after a few laps.
I have seen in a few threads, mounting it to the lower side of the crash bar.
Although (I think, it’s been a while since I’ve had it apart) it’s a box section, so how is the...
Does anyone know the spacing between the M4 holes in the crank pulley? (presuming the midpoint between the two is the crank bolt hole)
Need to make a tool to pull mine off, however I'm 140 miles from the engine.
Thanks :cool:
Hello,
I've been looking for the Clio 182 workshop manual, found a thread on here but the link was dead :(
I'm attempting an engine swap this weekend. Will be doing both belts, dephaser, water pump and clutch whilst engine is out.
Does anyone have a copy to send?
Someone have mercy...