Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
my fuel pump, cut of valve, ignition system and other stuff isnt working on my car it started then cut out with relays clicking rapidly which eventually stopped and now it wont start no sparks or fuel, think my ecu has died, would a ren 19 16v one fit or any other clios, and has anyone in yorks...
started my 16v up today run for about 4 secs then cut out plenty of petrol in it now when i turn the key to start it doesnt start but in the box under the bonnet with the relays in one keeps clicking constantly until i pull the connector off it, this makes the valve on the throttle body open and...
ok,
story i have a 16v clio with a willy lump in which is re-con (4000 miles)
gearbox rebuilt 3000 miles ago
in the last six month it has had new
steering rack and column
bearings all round
ball joints
struts and springs (-40mm)
discs and pads, starter motor, alternator, pas...
WILL ASTRA GTE DIGITAL CLOCKS GO IN A 16V CLIO IF YOU HAVE THE GEARBOX TRANSDUCER AND LOOM, I HAVE HEARD OF THIS WORKING BUT JUST WONDERING IF ANY1 AS ANY IDEA
Had 7 clutches in my car since febuary
the centres keep twisting out, taken the box off and had it inspected got told the dowels needed replacing, did that,
skimmed the flywheel, replaced the clutch cable and pedal
and after all that the problem has started again today, the gear changers...
the engine my 16v clio seized up whilst in motion at 70mph, when the engine was removed and gearbox seperated the clutch was fie purchased a new engine and fitted the box to it now i have endless problems with the car eating clutches, not burning them out but physcally snapping them in two...
Clio 16v with a like knocking clunking sound which speeds up with the car and vice versa, very much like the symptons of a worn wheel bearing but a knocking instead of a whirling noise,
This can be felt through the footwell, started quiet then after ten mile was alot louder,
cheers in...
My clio has a leak which fills the inside of the passanger cill plate up (not the cill the bit between the cill and the car) then when i drive i can hear it slushing around then if i brake hard it comes into the car .
anyone any ideas
Thinking of doing this myself with a few mates who have some mechanical knowledge,
i have rebuilt the 2L engine in the car now which was succesfull,
Could some one shed some light on this and tell me:
How hard it is to do?
I will have a rear end smashed turbo.
What work is involved...
What would cause clutches to break in a 16v clio, put 3 different clutches in from 3 different manufactures and all have been removed after between 300 - 500 miles, the car has not been driving harshly but everytime the outer faces of the clutch are no longer attached to the middle so the inner...
i have removed both door handles and lock from my clio phase 1, the boot id completely smoothed off except for the boot lock if i remove this how do you fit some mechanical back up device incase of the battery going flat?
any ideas?
What effect would a renault 19 16v box have on a clio?
Would the intial acceleration be better?
Will be running the box on a 2l willy engine modified with cams, port & polish, chipped, balanced bottom end
packed up tonight!
The story....
Bought a 2 litre lump out a willy fitted it myself kept the clutch which was on it looked fine after about 500 miles packed up grinding noises and clunking from the box sparks coming out the inpection hole.
Fitted a new ebc sports clutch with spring and...
Took my car for the test again and failed for the drivers side brake being only half effective as the passangers when you throw the brakes on the passenger locks up where as the drivers continues to rotate and doesnt lock up at all,
Would a new caliper solve this?
tryed cleaning the pads...
my clutch went in my car, lifted the engine the clutch was in four pieces fitted a new bb one loads of other bits now still having the same trouble clunky sometimes when changing gear and sometimes grinds especially when taking the revs to 6k+,
Any ideas?????
Mot tommorrow again took it to another garage about 2 month ago with the de-cat on and passed emissions no problem at all,
the car is a 1991 j reg i believe the car will be ok because it is pre 92 K is this correct will it pass at the other garage again
Noticed you have no handles or locks on your car, same here on remote solinoids, have you took it for mot yet cause down my way they reckon it will fail.
Does anyone know the part number for the metal power steering pipe which goes from the pump across the block to above the gearbox where it connects to flexible hose.
Please Help