Search results

What the best way to do this ? Found out my rad fan doesnt operate while it was at birchdow. I want to run a switch to it for now until I can figure it out. If put 12v directly to it its fine. Tried swapping the relays to see if it was this but the same so possibly a break in the wiring...

Ive got the epas rack fitted to my clio. Should there be a plug connection to the steering rack itself down by the subframe ?

Anyone know what clips I need for the upper roof plastics which are run along the roof liner ?

Anyone else struggle fitting them ? Fitted the boot and bumpstop from the old suspension but struggling to get enough of the shaft and thread to get nut on. I may have to get my dad to sit on rear tomoz to get some more weight in the back. These are replacing the koni kw rears so may have to...

Bought some new washer pumps not genuine and appears to leak via the rubber bung which goes to tank. Tried the old one of the renault pump. Is this common issue ? Also one pump ive left disconnected as i dont have rear wiper, the other pump i connected 1 single pipes per outlet but only get...

So my steering rack insnt central, ive pit the oem wheel on and wenrt to get tracking and wheel is on the piss. They reckon passenger track rod is too long as they have run of thread for adjustment. Do i need to disconnect the rack from inside the engine bat to try get it central ?

So ive been trying to resolve the noise i can hear from passenger side. Swapped a hub and a driveshaft and the noise is still present so to me im either unlucky or its gearbox/ diff related. Can't hear it so much with the car on idle 😫. Definitely passenger side only you can hear it. I was...

Need to replace front wheel bearing on passenger side. Is it SNR the brand to go with ? Anyone know best place to get them from ? May aswell do both

I have an exhaust hanger for centre pipe but the location thread is damaged from the old bolt which had snapped. Any recommendations what to do ? Anyone else had this issue ? Need to get it on a ramp. Currently zip tied

I have an epas kit with this connector, have people rewired and got new spares that fit or just jointed the cable from here ? If so what did you use ?

Anyone got a pick with dash removed ? Need to see where the heater ducts are fitted behind dash and if i have them all !

I have a squib here and its different to my other which goes blue or yellow in the window. Is this set correctly 🤔

Anyone know part number, need a couple of these.

Is it worth getting this done to mine prior to getting group n timing and map at Efi ? Anything else worth doing along side it ? Running a miltek and decat.

I have a mismatch of bulbs, side light bulbs are different. I have xenons and was it silver vision for indicators ? Any ideas who's best or is it just ebay or amazon search best ?

Anyone bought one of these, i know they are bloody expensive but looks nice. Assuming all is the same apart from the carbon base piece.

Currently have a miltek system with decat. I know the Yozza is always mentioned, Pure motorsport one any good ?

Is there a route to the batrery from steering column without have do drill a new access hole ?

Any ideas ? Not sure if its because ive mixed looms or uch kit or a fault that's occured. Noticed this lastnight when putting car in garage

Going to be putting my white clio on the road soon and covering some miles and maybe get a trackday in. Been reading on here about soft sidwall flex and going semi slick route like ns2r , ar1's or advans. Whats people's thoughts and looks like a 195/50r15 is what i need. It won't be used...

Anyone tell me what and where i can get the part for here ? Was it like a plastic insert ? No idea now what they were and if i still have them 🙈

Been at Oulton Park today and was speaking to a guy who used to compete in the clio cup, he mentioned getting a megane keyed pulley fitted when getting the cambelt done. The car will get a hammering on track so he said 100% do it. Also could somebody tell me what the part number is , i will be...

Hi , does anybody have some of these in there spares or know where i can ge 2 from ? I broke 2 on removal and trying to reinstall this. Ive had a look on ebay and a fastener website but cant find this particular one.

Can anyone tell me the length required ? The car isnt with me and asking a friend to make a cable , does anyone know what lenght is sufficient to route it the oem way ?

I bought a used alternator set up with cup mounts butvi think the guy said it wasnt a cup alternator but was the same , possibly a ph1 diesel ? Any ideas people ? I can get some pics and see if i can get the part number , it is a valeo unit. Just going to collect it from the place its been tested

Any guides on here how to put it all back in , been a while since removed it all so cant remember what order to do it all 🤔

Ive sold my seats so need something new. Quite like the sabelt ones in tweeks as i have sabelt wheel.

Is everybody running 75A alternator with epas ? I havent wired mine in yet but was wondering if the 75A stuggles then having to power epas aswell ? My alternator i purchased with the brackets clearly is not working 😕. I have seen i can get a cup one fron RPD. Does anyone know if this is the...

So ive got my clio running but have just got the stop light coming on now. Checked while running and only at 12.3v so alternator isnt charging , my alternator plug is missing of the loom so its just soldered on. I bought the cup alternator set up second hand so the alternator possibly may have...

All my looms either dont have a plug and have just been soldered and one loom has a plug but it doesnt push in. Can you buy the plugs from somehwhere ?