ClioSport.net
Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
-
When you purchase through links on our site, we may earn an affiliate commission. Read more here.
Airbag resistor 3.3ohm but what wattage?
- Thread starter GRitch
- Start date
Found in another thread.
Must admit I was never asked anything about Wattage when I went in.
Must admit I was never asked anything about Wattage when I went in.
Yea just try asking for that code!
172 Ph1
I haven't looked on my car but I'd guess its a single plug airbag not a 2 stage with 2 plugs , so will i be needing just one resistor for my Ph1*2 ?
Two connectors - two resistors!
Depends if its steering wheel or for bucket seats.
For the seats. Its one resistor for the airbag, and another for the pretensioner/warning beep.
I fitted my buckets but am still using existing seatbelt, so still have pretensioner and beeper wired up, so only used one resistor per side.
If using harnesses you'll need two per side.
If its for aftermarket steering wheel. 182's you need two resistors.
For the seats. Its one resistor for the airbag, and another for the pretensioner/warning beep.
I fitted my buckets but am still using existing seatbelt, so still have pretensioner and beeper wired up, so only used one resistor per side.
If using harnesses you'll need two per side.
If its for aftermarket steering wheel. 182's you need two resistors.
172 Ph1
Picked up my Resistors at last 22p each @ maplins , now I need to find the time to fit my new wheel
