Recent content by AdamCup

I’ve had to make a hard decision and unfortunately the time has come….. I’ve decided to part ways with my track car project. It’s been a long 3 years and I can’t see an end in sight. Family commitments, house projects, and a new job have taken priority. Plus I don't have a tow vehicle or trailer...

I've got one and you need a decent size compressor to run it properly. I've managed to sand blast bits and bobs but my 50L compressor struggles to deliver the constant pressure needed to get a good blasting action, does the job eventually. I've modified mine so i have an inlet fan and an...

MAM ? Some quote the load per axle rather than MAM.

If it is the circlip, don't bother with getting another circlip.... once they go, they will go again. Get a bolted one or a 182 gearbox.

Circlip or gear linkage

Does the speedo increase once in gear and little rev ?

If it's not the gear linkage.... it's gearbox out and then you'll get your answer.

If it was the clutch i would expect the same for any gear. Gear linkage ?

This, check your belts !

Off side drive shaft bearing bracket ?

Looks a little small to be a wheel bearing outter casing, how big is it ?

I'm sure most don't but for the people who do.......

Soooooooooo, an update...... I've been working on the rear lately, as and when I can. With the rear beam off, there was some tidying to do on the underside. Some light rust patches, gone with a wire brush, treated and then sprayed over with some Hammerite. Fuel tank refitted with new bolts. I...

Nice, best colour too ;-) Check your exhaust mounts, exhaust looks a little to the left