Recent content by Barryr33

Turned out to be engine mount. Slapped a powerflex insert one in and changed the centre exhaust mount as it was like an elastic band. Car is spot on now with no catching. A slight bit more vibration in the cab but I can cope with that.

Will check that one out too whilst I’m at it.

Car is back today as got snowed in. They have raised the height of the exhaust and it is clearing better now, the upper engine mount is as soft as a jelly, will throw a power flex yellow one in and the middle exhaust rubber hanger is worn and saggy - why they didn't replace that one i don't...

Car is back in garage today for them to have a look and hopefully re adjust. They can’t do it till end of day so hopefully it will be fine in the morning.

Well I’ve had a play about and I think it’s knocking. I have adjusted the middle hanger and pulled the exhaust up a little. It’s not as bad but there is no more adjustment. If I grab the cat there is movement with the engine but I can’t get the engine to move from under the bonnet. I’m...

OK I’m thinking it’s more of a loud exhaust note or leak under pressure. Looking up from underneath where the cat joins the down pipe the left hand spring bolt is loose. Either spring has broken or a spring cap has come off. With the movement of putting a new exhaust on I guess it could have...

On further investigation the middle rubber mount is saggy but they put a new rear one on! Wtf, why would they not change the middle one I don’t know! Is there an upgraded poly Bush middle mount?

Just had it off and it’s been changed already by a previous owner. It’s the power flex blue and putting a screwdriver through either end there is tiny movement. One of the heat shields does look like it’s got a fresh scrape mark on so I’m wondering if the garage has not got it set right

Cheers wil check it out

Cheers gonna get it u on axle stands this morning when it warms up a little outside and have a good look. I’ve seen the purple inserts at Euro’s and I have one round the corner from me.

I've had it up not he ramp at home and can't see anything obvious. Will have another look tomorrow. Will also check that dogbone mount.

Well it’s not been done I don’t think. Could it be as simple as that? The car has been sat over winter covered up.

Doubt it's anything to do with exhaust but just had car MOT'd and a new Ktec exhaust fitted at my local garage. Once car is war if I pull away hard in 1st or accelerate though 2nd hard there is a terrible rattle (knocking) noise coming from engine bay area. If I rev the car with no load there...

Attempted to replace leaking water pump today and do aux belt. It looks like the aux belt was not changed when the cambelt was done a few years ago. Managed to change the belt but had no chance in getting the water pump pulley out. I got the pulley off but it will not slip passed the arm...

Sorry @Louis' I contacted them and asked for a full belt change and dephaser and that was the price they gave me, he was busy so all I can guess is they have misheard me. I haven't had mine done yet but will probably just go there after reading reviews on here and they are local to me.