Recent content by Elitesion

I have always been under the belief that for the money it costs to get a decent sized, correct rubber boot, replacement clips, grease etc and the mess it involves VS the pre assembled driveshaft, at the cost of a few quid more, knowing the complete shaft is new, ready to be bolted in, is easier...

You have inspired me to try mine on my drive so thank you. The sheets you also upload with the part numbers and OEM numbers are so useful! with each picture you post, you put the new package in the photo, so i am reading through the whole thread looking for you opinion on the part you bought. (...

Brilliant read! Did you manage to fit this on your drive, just using axle stands?

Just seen it's on 15" wheels. The only reason I ask is mine is on Gram's all round, but it's to low. I bought some Eibach Pro-line's to hopefully make it a more comfortable drive.

After fitting the Grams springs, esp on the rear - did you find out why the rear sat so high, that's a hell of an arch gap.

Thanks for the confirmation.

Thank you 👍🏻

This has been a great read so far! Don't suppose you could provide the AutoDoc part number for the injector you replaced could you? If i order them now, they should be delivered by spring for me to fit..... Thanks Ben

Good to know, thanks for the info 👍🏻 I will get in touch.

Thank you, I will be in touch.

Very nice, thanks for the recommendation, I will try to get in touch with him 👍🏻

Good stuff, looks like someone has asked if he still works in Bristol but no response. 👍🏻

Hi all. Looking for someone or a garage that can do wanders with these cars... Last mechanic I spoke to didn't know what CLIP was for some diag work. Swindon Cheltenham Gloucester Any recommendations would be greatly appreciated. Thanks

Thanks for this, I did notice the Clio badge had some lugs to it, cheers.

Thanks for you help