Recent content by finch wxm

I tried disconnecting CTS sensor it's not triggering the fan. Also tried another set of relays which are new so will have to test wiring and also bridge just to rule out the relays. Its could be an ecu signal issue.

Yeah I don't have clip. The fan works if I directly give it 12v. The relays that were in the car were quite new but weren't renault ones. Do If I disconnect the sensor while running or before I start the car ?

What the best way to do this ? Found out my rad fan doesnt operate while it was at birchdow. I want to run a switch to it for now until I can figure it out. If put 12v directly to it its fine. Tried swapping the relays to see if it was this but the same so possibly a break in the wiring...

Car went to Efi for mapping after having group N timing set while having a fresh cambelt, water pump, dephaser pulley and keyway Crank sprocket.

Car went to birchdown on Monday for a fresh cambelt and water pump and keyway Crank pulley fitting ready for mapping. I fitted a fresh set of injectors and spark plugs. Fresh injectors fitted. Inlet removed for spark plug replacement. All done ready for mapping.

Ive got the epas rack fitted to my clio. Should there be a plug connection to the steering rack itself down by the subframe ?

Pure motorsport Spacers fitted front and rear. Could have gone a little more on the rear but happy how it's sitting.

Managed to get my spacers fitted front and rear and raised the Kw's up 10mm.

This is how I left it last night. Need to s

More interior going in, hoping this will make the car more useable over winter and a little warmer. Handbrake coverfitted. I need to get the foam piece which sits over the gearstick.

I've gone for 18mm PMS front and 10 on the back