Recent content by Fraser.J.

Plasma table

My bad

That wasn’t his question

You might want to remove the door bars, working on the inside will be a nightmare with them in especially making lines/looms etc

Took weeeeeks to get my mini kit. Had to chase over 5 times to eventually get a “new” kit made and sent out after he sent them to the wrong address... Again poor fitment with odd size lines, one is excessively long. Would not recommend

Trailer

Ye fine. The nut is catching plenty thread

I know there isnt! That’s with rears full stuff aswell and RARB. The high pressure helps ya lose rear end grip, you don’t need it at knockhill. I’m running the same now on full slicks in my new Mini Cooper S.

AST 5100 with 90 front and 110 rear springs and roll centre kit? Aye you’re right that’s a shite set up ??‍♂️

Damn you ☹️

Knockhill requires about 50psi hot in the tears [emoji102]

I done a terrible job of keeping this up to date! I’ll not bother too much with chat. Inside painted Engine out M Dactory diff fitted New clutch and flywheel (single mass) 11% Kavs reducer pulley Look cut back, tapped and cage back in Seat, cage, cartek isolator, extinguisher fitted...

Errr I have a name. You’re welcome

It was the battery to box Earth. Thats the only earth onto the engine/box these have!

Thanks anyway mate!