Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Not sure if this is right place for this thread but... Last weekend I fit poly bushes into my dog bone mount and make the stupid mistake of forgetting the washers after I had to drill out the smaller collar bcos powerflex hadn't bothered lol.
Questions is will I be able to just drop the bolt...
Do I need to support the gearbox whilst changing the bushes over on the dog bone mount? Going to do it today and have read the guide on here but it doesn't say anything about this?
The gap between my battery and ecu bracket is only 60mm so could fit the pipe through. Anybody know wether the battery will slide back at all? Did getting a new battery just to fit this kit.
Did changing the pre cat sensor resolve this issue. My emissions light is back on this morning after going off about 3wk ago. I also got told lambda bank 1 from a code reader.
Fitted -40mm spring to my 182 at the weekend. Problem is one side is sat at a different hight to the other at the rear. Could that be down to a knackered shocker?
Also had serv, abs and traction light on this morning after driving a couple of miles, arrived at work and started up again with no...
Are 182 cup rear shockers the same fitment as 182 non cup shocks. I know the difference on the front(bolt spacing) bit can't see anything about rears. Thanks.
I've searched and searched but could someone confirm the length of wire to the pre cat sensor or a link to where I can buy one. Don't wanna buy the wrong one cheers.