Recent content by M.C..

Did you just change it for a cheap pattern part?

When I stripped the car out years ago I removed the interior lights. As the plug is still there I just thought it would be nice to have a bit of light when I open the boot now as my eyes are getting worse 😂 I got a couple of LED units as I have no idea where the original light is now and just...

Yeah spring rates are 525lb front springs and 400lb rears. Whiteline ARB, PMS strut brace, strengthened wishbones with powerflex black bushes, car with me is approximately 1100kg

Currently on Gaz golds Tbh I have not had loads of wear to the inside edge due to driving on the road

What do people recommend for track use but also driving to the track and limited road miles. It’s been a while since I had the alignment done and these were my settings. Camber was pretty much maxed out with camber bolts.

@Advikaz I got a new one from Renault just over £8

I’m planning on refitting the flywheel and new clutch the weekend what do people use to lock the flywheel so the bolts can be torqued up Something like this...

Got a link to the boot?

Thanks That makes sense I’ll leave mine alone then

Right as I have my engine out I have decided to change the clutch cable as it is easier to get to. I’ve got a Febi 172058 cable as it was massively cheaper than Renault. Just looking at the one in my 182 it looks different to the Febi but the Febi looks the same as the Renault ones advertised...

I have a normal clicky torque wrench "cheap version" that does 220Nm but need one that does 275 Nm for the hub nuts. Seen this Sealey STW310 which also does angles, it is more than I wanted to pay but nice to have angle feature as well. Has anyone used one or any other suggestions for not...

I’ve currently got my engine in bits and noticed a bit of damage on the crank pulley and casting so it got me looking I got lucky so will probably be buying this

Anyone fitted the protection plate PMS make? https://www.pure-motorsport.co.uk/lower-cambelt-protection-cover.html

As Renault have decided to not supply this part now for cam belt changes what pin do people use now? Or if anyone has a genuine pin could you measure the pin and put the sizes up please Thanks

I have a facelift trophy EDC currently on 45k miles the suspension is fine for daily driving, the screen is much nicer than the pre facelift and it also has physical buttons for the heater controls. I didn’t bother with recaros as it was standard with the alcantara heated seats (which are...