Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hi and welcome to Cliosport.
Common fault and I experienced it on my 182 in the last two weeks.
I replaced the resistor in the engine bay just by the windscreen to get mine working again.
Bought the resistor on ebay.
Do a search for "heater problems" as there are a few guides and walk throughs
FPS
Tactical;
Operation Flashpoint
ARMA2
Run & Gun;
COD4 Modern Warfare
COD4 World At War
Left For Dead (+ L4D2 is out soon)
Far Cry 2
Crysis
COD Modern Warfare 2 (only for single palyer though, forget multiplayer)
Classics/older but still good;
Counter Strike Source
Day of...
Highly recommend a Samsung LCD.
I have a 46" LE46A656 and very impressed with it.
Great with BluRay, 360 , Wii etc and Terrestrial TV
Check - www.hdtvtest.co.uk
- www.avforums.com for info and advice.
Got mine from John Lewis for price match & their 5 year warranty last year.
Beas
I would seperate the joint pop some in and around the joint. Put some around the joint and then put the clamp on. Then with the clamp in place put some more on just to be safe. Basically smear the stuff every where! :O)
The joint is always flexing and moving so my advice, so your not...
I would say go for a Miltek exhaust. Not too loud but not too quiet.
At low revs and idle a nice little burble but you can hear it when you put your foot down. Also doesn't drone when on the motorway and you can still have a conversation.
They also look and fit nice.
Got mine from K-Tec...
As Fred said!
I use/d some "High Temperature Gasket Sealant" from Tool Station.
Its a high temp silocone sealant. Costs about £5.
Used it to seal the joint from the CAT to the rear exhaust and works a treat. No more blowing and flexible.
Put it between and all over the joint, bit...
I can testify to a blowing Miltek at that exact point causing it to fail its MOT :O(.
Theres no gasket just that stupid clamp! I put a good seal of high temp silocone sealent on it and around the clamp and it did the job! Seems to be holding well so far.
Shame that I can't say the same...
The more people who bring this to Renault's attention the better I think. Like the bonnet catch issue, the more pressure that can be put on them the more chance we have of getting Renault to accept there is a problem.
We need as many people to visit a dealership and show them their steering...
OK guys, heres an update and a request for he p on this melting steering wheel saga.
I emailed Renault Customer Services and advised them of my melted steering wheel issues. I was called and was advised that they would help towards the replacement of the steering wheel but I needed to visit a...
I have one and fall into the category of low/average usage.
The battery life I have found is very good.
I charge it maybe once a week and it has never died on me. I use it for calls once or twice a day for a few mins at a time and a few texts.
For me its a great phone, slim, light...
Have you considered a Miltek 182 system?
Got mine from K-tec and fitted by a local garage. Great fit and sound.
Cost in total £360 incl delivery, (which was next day) for the exhaust and about £30 to fit, so well within what you have been quoted.
I would assume most garages would have...