Recent content by Rob_Willow

New 520x90mm plate on, I was going to use double sided pads but non were included. So screws it was. Also fitted new inner tie rods, gaiters and track rod ends. The grill was also missing some clips so had RPD send out new ones. Also purchased engine cover stainless screws off eBay and put them on.

Jet washed the front seatbelts Full wash and decomtamination Meguairs Clay Bar AG super resin polish Power Max Tyre Dressing

Great work Steve! I’m currently refurbishing my Arctic blue 182, but the efforts you have gone to make mine look poor! Haha Keep up the good work, and can I ask, is that Goonzquad’s YouTube music playing in the timeframe videos? 🤣

Passenger sill finished off, tried to straighten the jacking point, rubbed off all rust bubbles and treated them, covered over with primer. Gave the front end a clay bar, removed the plate as a new one is on the way. Fixed the washer jets and leaking Reservoir too (MOT fail precious time)

Trying to diagnose the ABS/ SERV light, my friends diagnostics pulled up these 3 codes. Anyone have idea what they refer to, or will I need Clip to pin point further?😎

I had it collected on a flatbed from Leeds in Feb, it’s been garaged since then. Probably it’s twin :)

Some more movement on the 182. All the interior is back together, seats Bolted back in underneath. Swapped the cat over and sold it to the cat man, not happy with the olive joint so chopping it off and installing a fabricated connector that I made on the flamer project All new shocks on...

Some more updates on the 182! Pretty much finished the rear now, bumper is back on. Cleaned up two alloy wheels which were heavily pitted. Brushed down the drivers sill and protected with primer. Still working on fuel filling surround. Side skirt is now back on. Working on OSF arch. New...

I’ll see if there is any adjustment when I get time.

Not fitted it yet mate, however the last one I bought for Flame Red 172 project went through MOT fine with no emission lights.

Rear underneath all rust treated and Hammerite painted on. Polished up the exhaust, haven’t a clue what brand it is. Just had a delivery from RPD, so threw the new rear shocks on.

I think I would be climbing the walls if it wasn’t for the little Clio! 🤣

I ordered a pattern one from cat2u. the old one looks tired and it generates some cash towards the refurb work.

Cleaned up the rear beam, wire brushes, rust treatment and soon to paint with black Hammerite. The rear callipers look brand new. Had a sift through paperwork they were installed 2017, along with discs, bearings and pads. The brake lines are also Goodrich New Catalytic Converter just arrived too.