Recent content by SuperCinq

Is that the fussy focker thread? LOL

dave-in-manchester?

It's my car! Front dampers and springs look pretty new as I remember, I can whip a wheel off and send pictures. Original front wheel arch liners are all in good condition and all properly attached.

That's my Febi tank listed on eBay and works well on my sprint car, the problem I found with the cheaper versions is the top pipe collapses and distorts out of shape......you probably wouldn't notice until you remove the top hose or it starts to leak.

I have a hill climb Clio 172 which is fairly modified but still keep it MOT'd It's good to be able to test out any modifications on the road before getting to the event, a 10 minute shake down to make sure nothing falls off gives me a bit more confidence on the day.

Double gay!

I've had two Spiders, still have the yellow one but sold the blue trophy last year.

Hello again, I know have the Gen90 up and running but I have noticed that the temperature gauge on the dash is no longer working. The water temperature can be seen on the laptop through the software. I have tried the clocks on another car and they work correctly. Any suggestions?

Hey guys, tried the cable on another computer with no joy. Tried a different cable after a trip to K-Tec and all is good.

OK, I have now tried plugging the USB cable into the laptop without being connected to the ECU and the device manager does notice a change. The only thing is that when I plug in the USB cable it removes a USB composite device and when I remove the cable it adds a composite device to the list of...

With the device manager open, when I plug in the KTEC USB stick it is recognised as a storage device, when I plug the ECU cable into the laptop nothing happens, it is not recognised at all.

It's not a standard USB cable and specific to the Gen90 ECU I believe? The car starts so the ECU must have power, all I need to do is set the TPS I would have thought that if the software is asking me to manually choose a port it would list have listed all the ports available and then I chose...

No spare cable unfortunately, the current cable is new and unused and would assume that it should be working perfectly? or do they have an issue with failure?

It's Windows 10

Thanks for getting back to me, I have installed the FTDI driver supplied on the USB but when I attach the USB cable the device manager doesn't recognise or acknowledge it. I have the USB cable connected to the ECU and the ignition is switched on.