Recent content by TIG ACM

Sunglasses I'm selling if there's any interest on here... http://www.ebay.co.uk/itm/181540196047

Does anyone know the piston size on the wilwood midilites that are in the jamsport/ktec kit or the piston size I will need for my 172. thanks

It was at shakespeare, hopefully will be going again later in the year once I have sorted out the ECU issues. It did run a 13.8 but that was with a turbo and running rough. Santa Pod is supposed to be quicker now after they relaid their track last year

I did a 14.29 in my 172cup (exhaust, filter, map, no rear interior)

172 2001, 88k, most service history, just been serviced. belts last done at 45k 2008 so due very soon. Little bit of carpark damage, Decat, K-tec Steath, Map Any idea?

As its a classified add it was priced with some wiggle room.

http://www.ebay.co.uk/itm/181151350686

The car has: Tubular manifold and ss exhaust, decat and a airfilter. It idles fine but when driving it intermittently looses power, foot to the floor and nothing just it misfiring and bogging down. We have changed coil pack, leads, plugs, cranksensor so far. Ideas on what it could be...

I can cut it :)

As said above, phone up get settlement figure before you do anything. Depending on their terms and conditions it may not actually be that bad. Secondly if you girlfriend cant hack a 5 year deal this time, how is she going to cope again? £200 a month for a car is nothing really by paying less...

Thanks Dan, I wanted to check what I thought it might be, I didnt have much mechanical knowledge until about 8 weeks ago when I set about swapping the system over so am still very green. Didnt want to be missing something blindingly obvious.

from what I can see the vac hose looks fine, i am going to take a few bits off tomorrow afternoon to get a better look and look for small leaks/holes. Had a issue with wastegate yesterday where it jammed fully open. loosened off the down pipe and it free'd up and moves fine again with the...

It was a setup that was on another clio and dropped onto mine. Worked fine in the other car... ECU is a mapped standard one by ktec, Its a LPT kit from ktec few years ago, Boost control is a vac acutator linked to the compressor housing. I know the ecu isnt the greatest but i cant see how this...

Having some problems with my 172 cup turbo. Giving it stick from stationary, through the gears up to 5th the boost is fine, runs and pulls very well. Boosts to 10psi.... Lift off, slow down, accelerate from 3rd and it boosts to 14psi, engine misfires and sounds awful..... Slow down to 20mph...

I have used this with mixed results. It is by no means as shiny as it shows on the car. I had a sheet of carbon and put it next to this and it probably is the best imitation I have seen. However, it doesn't seem to wrap very well. It looked great when my mirrors were first wrapped but it is...