Search results

Anybody?

It's definitely not switching when it's hot it reads 30mv sometimes going to 40mv its a new NGO sensor old read exactly the same! Belts have been done with the correct tools including cam pulley holding tool! How you check the dephaser pulley?

Right had another look at this the pre cat lambda is always reading 30/40 mv I've swapped it for a new one buts it's doing exactly the same could this be a wiring problem then?? Post cat reads about 340 mv

Thanks a lot for your help will try it tomorrow

It says no misfire detected but sounds like it is

Also had it plugged into a launch diagnostics as well same readings

I actually agree the live data is not the best on snap on on these cars unfortunately it's all I have! I've put a new coolant temp sensor in and it's reads fine on the diagnostics and the engine is the same temp as it says so that's ok now! But the car is still exactly the same??? Any other ideas?

Live data was being read with a snap-on souls pro. The coolant temp is reading correct it's the ignition advance on live data that isn't going above half a degree?

Hi, I've just brought a clio 172 with a problem just after some advice?. cars has a very low tick over speed and often cuts out after revving it up also under load it splutters/misfires when you accelerate, if you accelerate very gently it will rev through this? Also when plugged into a...