Search results

I will try swapping light to see if fault moves. could it be a relay ?

Hi Guys, when I turn on my head lights I only get the drivers xenon come on. I have taken of the bulb plug and put a new bulb in the holder but not fitted it in the light just to test to see if its the bulb and found that when I turn on the lights the drivers one come on still but the passenger...

Just checked the torque of the centre nuts and they were all well over 175nm so I have backed them off to 175nm. Will test drive tomorrow. Thanks all so far for your help.

Don't think so, they all seem tight.

After 80mph, when I accelerate the car hums and the steering resonates like a phone on vibrate ( I know....strange description) . But all started since spring bolt re fitted. If it was to tight or if it changed the exhaust position enough to touch steering rack.

Yer, fine vibration. Gonna try moving engine forward in case it's touching rack. It all started when I notice one of the spring bolts between the manifold and the cat was loose. Tightened it up and now this.

I haven't fitted it, but it does have purple bushes. Wheels are fine and checked. As I said it's more resonance.

Could do with you expertise guys. thanks

Hi all, Clio 172 resonating at 80mph + . More speed related than rpm. Ounce at 80+ if you back off accelerator it reduces but as soon as I reapply it increases. But only over 80mph. Any ideas lads thanks:dapprove:

Hi all, just to keep you all updated the problem was the lambda sensor.

Well I have found the problem, it was the throttle pedal. £££ how much is one of these new.

Really desperate to sort problem, I have fitted new thermostat and temp sensor and new tdc but wouldn't run properly at all with new tdc. so I fitted old tdc which had a odd tick over but it now ticks over fine but tries to stall every time I press the gas pedal. Help help help lol

Hi Guys, I have a problem which is driving me nuts. the car start and ticks over fine. if I press throttle it tries to stall unless I press it slow. ounce revs go up I can rev the hole range but if I press pedal quick it just tries to stall. any help

Total mind block, Whats meant by TDC

Hi All, I have been suffering the 4k rattle for some time now and finally solved it. I found that one of the spring clamps between the cat and the manifold was loose due to loosing the washer at one end. I fitted a new washer and tightened up and now rattle has gone but I have gained a...

Thanks guys

Hi, My names Rob and I am now the owner of a mk2 clio 172. And can't wait to find out more about them ( good and bad).