Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Morning all,
Having a few problems with my PH2 172.
I've recently had the engine out and replaced the head gasket, valve stem seals, cambelt (dephaser was previously replaced 4000 miles before), and all other gaskets and seals I came across in the process. It has also had the air con and the...
Hi guys
im in use process of installing a 6 point cage in the clio but have run into a problem. With the rear hoop in and where I think it goes the weld in plates do not sit anywhere near flush with the floor. Also the rear bars to the arches look to sit a bit far in.
Ia it just a case of...
Hi all,
my friend is having problems with his 2003 172.
We we replaced the rear calipers and rear discs and pads a while ago and ever since after half a mile of driving the SERV ABS ESP STOP and Handbrake symbol all come on.
The brakes feel fine and the abs doesn't appear to be kicking in...
I was just wondering if anyone could briefly explain how to do this.
I also have a starter button with separate switches for fuel pump and ignition. I guess this is just off the barrel?
are there any wiring diagrams for this part of the car.
Cheers
Hi all,
Has anyone got a interior wiring diagram that I could have? Mainly interested in the starter/ignition side of things if they're separate?
thanks in advance
Ben
Hi guys.
How do the track guys go about removing excess wiring for the 172 we've got rid of the heaters and the lot really. What's nessesary for it to run?
Hi guys
was woundering if anyone has done this. were planning on having no ABS in the 172 so as where at it may as well run all new brake lines with a brake bias for the rear.
has anyone got a brief overview of what needs to be donw with the Clio.
Cheers
Cliff
Hi guys
Will be fitting the head back onto the block this week. i was wondering if a special sealant is needed between the head and the rocker cover or will and gasket sealant do the trick.
Also what torque doe the camshaft bearing bolts need to be tightened to?
Cheers
Hi guys.
Just in the process of refeshing my engine for my 172. The head is off for a bit of work on the inlets/exhaust.
Ive just measured the flatness of the head and its 0.05mm out .
Does anyone know what the tolerance is before it needs skimming?
Cheers
Hi all,
Im Ben. I'm 20 and I'm from Derby
I picked up my 172 yesterday.
So far so good, feels nippy and nimble and once I get to know it I can imagine it'll be a cery capable car!
I swapped my Audi S4 for it (with a bit of cash my way). I've always been tempted by a 172/182 but have never...