307 Splitter Fitting...Any Tips/Advice??

[P17 TOO]

Have one of these on the way so was just wondering if anyone has any tips or advice on fitting so it looks spot on?? Also being a two part splitter is there a way that looks good of disguising the join in the middle??

Thanks In Advance!

 

[James.f]

Just use some self tappers fella, those will hold it in place fine

 

[richy22]

As above use self tapper...you wil need to trim some bits of the end though..heres mine you cant really notice the join

Edit more recently since using a some trim stuff on it..

 

[TimR26]

I took the bumper off to fit my 307 splitter lot easier than struggling on the floor with it. Used an electric screwdriver to drill through splitter and bumper then secured with self tapping screws.

 

[clayton6]

I took my bumper off fit it as well, was much easier. Just start from the middle with 1 half and work round, bends quite easily.

Don't make my mistake and forget to screw back in the s**t guards underneath, mine dropped down on the motorway yesterday and cracked all the way up....will have to buy a new one now.

 

[StevieG-09]

Don't make my mistake and forget to screw back in the s**t guards underneath, mine dropped down on the motorway yesterday and cracked all the way up....will have to buy a new one now.

This exact thing happened to me! was so embarrassing having everyone looking at my car thinking 'WTF is that scrapping noise'

I loved my 307 splitter, but it split round the edges and had to go
Easy enough to fit though, just make sure the split is in the middle otherwise i can look abit silly