Omex crank sensor help please

[sstruth]

Hi
I have a clio race car and I am trying to get the Omex ecu to work. I can not get the stat sync to turn on, it has a brand new cps and I have tried many gaps. It is reading rpm and lots of other stuff that I do not understand, I have tried everything I have found through google, inc checkin jumper settings and swapping wiring polarity, any advice is much appreciated.

Thank you

Simon

 

[MicKPM]

Im afraid I don't have much experience with the Omex range of products or the software but If its "seeing" rotation the problem is not CPS sensor related and is more likely going to be a config or trigger pattern issue.

Are you sure you've correctly installed the loom and have correct power/earth distribution everywhere?

Mick

 

[Dan519]

is it a cup racer? If so you'll have to change the flywheel as the Marelli trigger pattern required an extra tooth to be modded. Tried it before and Omex won't run it

 

[BIGASH]

As Dan says if its a cup racer that normally run's Marelli then the flywheel needs to be modified. A few details on page 14 of this thread http://www.cliosport.net/forum/showthread.php?540049-newbie-with-a-clio-cup-race-car/page14

 

[sstruth]

Thanks, it has a standard 172 flywheel so should be ok on the config side, tried a zetec cps but still no joy!

 

[Dan519]

what map is on your ECU?

 

[Jay Payne]

Think its your map/trigger patter mate, as said via pm 400rpm crank speed isnt right

 

[Dan519]

Email me the calibration file and I'll see if I can find an issue

enquiries@519automotive.co.uk

 

[Daverb]

Im running a Omex with a Clio Cup Race car.

The zetec sensor helped with me - if your not getting sync with that it has to be your settings.

Omex are very helpful too if you give them a phone.