Is there a sticky/guide anywhere with how to lift the engine (possibly with pics)
Have a Haynes but they use 3 words where on will do.
Cheers Bailey
Have a Haynes but they use 3 words where on will do.
Cheers Bailey
radiator, sump,
pretty much every thing i fink..correct me if im wrong sum one but you dont need to but its advised drain the power steering brakes and stuff.
What do i need to do about fuel lines?
stock is £85 or so, GSF etc. will be cheaper though, yours isn't gone, my girlfriend will post you in the other thread cause she is sitting on my knee typing
Ok am all sorted ready for tomorrow morning, aprart from mani and fuel lines.
2 small problems though, when i pushed out the roll pin it demolished it, is there any other way of sorting it (ie a bolt of the same diameter) as renault will be closed tomorrow or do i even need to replace it?
also when i withdrew the passanger driveshaft the thing the tripod sits in also came out (not good i am presuming) have it seated back again but found this, does anybody know what it is, what it does and if it is essential?
![]()
So this is the diff circlip? Where is the rest? thought the diff was on the other side (this was from passenger side) how much is this part and what do i ask for?
Cant get into a dealership as i work in the week and my car is off the road
Will this be the reason my car wont go?
I've been menaing to look at your thread about your car not going for ages if this was broken before ou took the shaft out them yep this would show why yor car not moving.
I'm sure someone on the thread has mentioned this though.
But the speedo never went up whilst it was running? could i have done it when removing the driveshaft?
Would i be best off putting a new box in or will it not matter as long as i replace this bit?
Will ring reno on monday, jus need to know what to ask for. :S
Yep should do.What you recon then, have an RT sitting on the driveway, whip the box off that? will is just fit straight on to the shafts clutch etc?
Completly forgot to ask where the hell this goes and what it does...
Presum its the circlip to hold the washer with the tab on and the big cog thing in place...