clio 172
Just been fitting my 4 point Sparco Harnesses and have a little issue with the eye bolt fittings,
Now I have four of these Supplied with the harness,
Off which 2 fit the exsisting rear seat holes which is fine. Now how do I fit the lap belts, i.e here,
By the drivers door, and here
By the hand brake.
Now the eye bolts are ok for the rear but are too big for the original seat belt mounts. My question is has anyone expanded the holes for the eyes or been able to buy correct eyes for the front.
The Fixing by the hand brake is the 8M x 50mm fixing suggested to fix the subframe to the car, has anyone found a 50mm eye bolt to replace this fixing and allow the harness to be clipped in. This seems like the simplest solution.
(Just a couple of pic of buckets overall)
PS, no comments on harness locations, once I find a solution to the mounting point issues I will move them to the high mounting point but this is also a smaller hole for the eye bolts.
Thanks in advance
Now I have four of these Supplied with the harness,
Off which 2 fit the exsisting rear seat holes which is fine. Now how do I fit the lap belts, i.e here,
By the drivers door, and here
By the hand brake.
Now the eye bolts are ok for the rear but are too big for the original seat belt mounts. My question is has anyone expanded the holes for the eyes or been able to buy correct eyes for the front.
The Fixing by the hand brake is the 8M x 50mm fixing suggested to fix the subframe to the car, has anyone found a 50mm eye bolt to replace this fixing and allow the harness to be clipped in. This seems like the simplest solution.
(Just a couple of pic of buckets overall)
PS, no comments on harness locations, once I find a solution to the mounting point issues I will move them to the high mounting point but this is also a smaller hole for the eye bolts.
Thanks in advance