ClioSport.net
Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Brigsy's latest activity
-
Brigsy replied to the thread Inlet manifold upgrade options?.Save your money unless going 400+hp, stock inlet is not a restriction. Put the money towards vag or ndo gearbox conversion instead... -
I've had a little look around but haven't come up with anything, may just have to slap some upgrades on and make it a worthwhile trip to...
-
Brigsy replied to the thread Oops I did it again... Adey's Clio 200 EDC.Might be possible to get the map off the old tcu and flash it on. Wonder if mpps or similar would do it
-
175 miles covered with no issues so far on the TCU, not beaten the previous best but going well. Also passed its MOT today, minor for a...
-
Brigsy replied to the thread Fuel Line Fitting.Masking tape and 1mm cuting disc is ok. The shears are epic though if doing loads of cuts as gives a very clean sharp cut where grinder...
-
Brigsy replied to the thread Fuel Line Fitting.If its your first time using the ptfe then buy a set of large electric cable shears to cut it. Makes life very easy when fitting. Also...
-
Brigsy replied to the thread Fuel Line Fitting.Use ptfe/nylon overbraided an line. Its hard plastic with overbraid and never fails. Basically more or less same as oem with braid...
-
Same with the fuel line itself! I nearly set my RS Turbo on fire because I had bought Chinese braided fuel line, the rubber inside...
-
Brigsy replied to the thread Fuel Line Fitting.Torques/motamec an fittings are always pretty decent from experience. Avoid any unbranded chinese shite though.
-
Brigsy replied to the thread Fuel Line Fitting.
-
-
Brigsy replied to the thread Fuel Line Fitting.Id personally renew the lot straight back to the tank in an6 pipe and use one of these on the sender. It might fit the connectors on the...
