Recent content by Doogimus

@NorthloopCup ok thanks very much for your help.

@NorthloopCup i checked the pins on the ph2 loom. The pins used are 62,61,17,7,13,82. So pin 75 is not located on the tps.

@http://www.cliosport.net/members/northloopcup.61663/ i checked the tps on the ph2 loom. The pins used on that are 62,61,17,7,13,82. So pin 75 is not used for the tps.

Cheers

The 3 pins used on ph1 loom are 48,74,75

Cheers. Ill get on the case the morn.

Read up a bit and found out i cant get tps to suit pin. Anyone know if i can use the 3 wires i need and which ones? Cheers

Hi i have a 2000 ph1 172. I needed a new engine loom so bought one from a 2002 172 thinking they would be the same. The problem i have is the tps. On my car its 3 pin but on the loom its 6 pin. Is there away round this? Can i get a tps to suit the loom and it still work ok?

Ill try those suggestions, thanks.

It's like orange scuff marks/scratches. It's on the back quarter, not the best pic I could find but the other side is worse.

Hi, I have cone marks on my car from cutting those corners at sprints haha. What is the best way to remove these? Thanks

Ok cheers guys

Hi. Im thinking of buying throttle bodies for my sprint/hillclimb clio. Just wondered if i would need to upgrade engine parts also. New valves, uprated springs? Thanks

Hi, ive bought ast top mounts but dont think i have them in right. I have the top hat then the rubber bit and place below opening and put the top bit on from underneath the bonnet. My problem is it is not centre and there is alot of play. Do i need to keep anything on from old setup? I have kw...

I had the decoder ring connected but not round the barrel as i was just checking to see if it would start before putting stuff back in final place. I put ring over the barrel and it start first time no problem haha. Thanks for those who got in touch.