Recent content by ed55j

Relisted. £2450

Very tidy indeed, looks great!

Interesting, will keep an eye on your progress

The wife's tidy 206 is up for sale. http://www.ebay.co.uk/itm/Peugeot-206-Look-2007-1-4-Petrol-3dr-Manual-Hatchback-/291661397855?_trksid=p2141725.m3641.l6368

Your'e right, didnt read the op properly doh

Try the starter motor, the solenoid can stick. Give it a tap with a hammer

You can fit the plate with the box in situ, its a fairly straight forward job and does away with the circlip. Thats what i did, save removing the gearbox which is a pain of a job.

I have faulkner springs on my b14's. Have a look at jjc, they do a wide range of length/rates.

Bilsteins

2nd pic is a cracker! Looks great

I had it the other night df0129 (among others) was from water getting somewhere where it shouldnt have. Went a bit quick through some deep water and put it in safe mode. I checked all the electrical conections under the bonnet and gave them a good spray of wd40. In the morning it had cleared and...

Make sure their isnt a blob of weld anywhere on the joint. Might be easier to remove both sections and get them in a vice?

Looks great!

Check the usuals - exhaust knocking on something, ball joints, top mounts, cv joints, bushes in good condition

It says on the rack, smi is the most commonly used one.