Recent content by grant29mac

nahh don't think so they say it's fine for rallying

right right get you now, yes it is. thanks for your help

thanks for the advice:up: I get what you are saying for the 2 front parts, on the arches do you put any strengthening in or straight on to the body shell?

ohh aye, its a CLIO 2

Hi Im building myself a tarmac rally car so got my self a 6 point bolt in cage. Can anyone give me pictures/ advice on how the reinforcement plates should be welded in the front bar and main bar look straight forward, just the back part (which attached to the arches). pictures of all would...

hi can anyone tell me what length the o/s drive shaft is in the clio 2 1.4, 1.6, 172 and 182 cheers

so have done a few things with the clio since iv bought it first of all got a sticker for the passenger recaro runner I then had to get something else so ordered a ktec panel filter and H&R springs(on un till iv got the funds for a set of KWs) next is the H&R spacers went for the...

Iv had Clio's since iv started driving mainly because I'm a mechanic working in a Renault dealership, (cheep parts also;);)) in this time if come to really like them so decided to get a sport. Iv been looking for one for about 6 months now looked at a few but none stood out until I seen this one...

love the car mate! You may of said and probably missed, but what exhaust is on it?

that sounds normal mate it should go up to half way then the thermostat should open lowering the temp a bit.

where did u get the battery cover mate?

nahh wouldn't fit totally different top mount

you use a locking pin for the crank which goes in once you take out the blanking plug on the front of the block. then on the 2 blanking plugs on the left hand side of the head comes out and they should be lined up

the center section is after the lambda sensor so shouldn't make any difference

under the bonnet to the right and inside the passengers door