Recent content by J9HHY

When I drive hard in my 172, water leaks out of rear washer jet as if nothing is stopping it? Is there some sort valve to stop this that's broken or the nozzle itself? Sent from my iPad using Tapatalk

I'm not trying to claim bragging rights that my car is 200bhp just simply showing that this setup didn't harm the performance. I pulls well, making max bhp at top revs. It was just an example of what this set up produces. Take 20bhp off if u wish. Regards the warm up, car was warmish after drive...

I had a go with this setup and liked the noise etc and a good strong pull but I had issues going on in my head all the time and wasnt happy with all the 90 degree bends, small airfilter and the fact the alloy pipe got pretty hot where it was so i spent a bit more and went for this. I havent got...

So 6 years on, I return to powerstation in the silver cup which was the first picture on here, mr steve 'o' owned. As you can see it made a health 180bhp standard. It had been well looked after and driven since then by a mr clark and I am now the lucky owner! Its had a few little mods now, ktec...

Glad it fitted alright in the end, bloody clios, every job takes double the time haha

Is there a rubber type bung underneath the ph2 airbox? Just took my airbox out and removed CAF in readiness for my filter and bend to come, put back on and when I drove car out of garage there was a rubber bung on the floor

Gotta have some life in them @Jamie86 im afraid as they are for road use

Hah I'm actually watching them ;)

Seen that @LeeP86 but I need them for 16"

Is it me or have the prices of these at least doubled in like 5 years? When I last bought some for my 172 I remember them being like £55 a corner, now there £155!!! Jeeze louise!

[/URL][/IMG] [/URL][/IMG] [/URL][/IMG]

Was thinking this but worry it may come loose http://www.do88.se/en/artiklar/hose-take-off-13mm.html

My only concern would be if that plastic tubing came loose and went into the engine. I'm thinking if I just drill a hole the same size of the outside diameter of the standard breather pipe, then push it in, no fixings (to avoid anything coming loose and going into engine) that would be ok, but...

@MRBILLYUK how did you find that setup with the breather pipe, did it stay in ok or keep popping off? I'm looking for a solution for a 45 degree bend as I can't find a 45 degree bend that comes with a breather pipe connection too.

I'd move it to where you said as that's where it was designed to be. Brake cooling is always good too. Plus I think a cold air feed from fog light isn't as direct as the original, to many 90 degree bends