Recent content by Mattrix

I'll be down on Sunday with a few mates, I'll be having a blast down the 1/4 to compare times with his VXR corsa!

No mate, mines a 05 plate. Do you live on Smithurst by any chance? you will remember my plate as it ends in 'KOX' haha

They are made by Janspeed but there 2.25" bore not 2.5" like the decat i brought 8-) i called Ktec today and they said the "standard" Decat is 2.25" bore as well so, ill just get one of these bad boys! cheers

i shall give them a tinckle on the morro i think! Cheers matey

If the HDDs already gone and now its complaining about memory, id probably look into getting a new one... laptops tend to go wappy after 3-4 years!

I could do but i dont know any exhaust specialists and im not sure if it would work! What Decat does everyone else buy?

Hello! Does anyone know what the Bore size is of the decat that KTec do? http://www.k-tecracing.com/show_product.asp?id=1901 I have a Janspeed Cat back system and i got a 2.5" decat but it dont quite fit right as my system is 2.25" so its blowing like a f**ker. any ideas? thanks...

What Decat Does you Guys have? like a plank i got the 2.5mm one thinking it would fit my JanSpeed..... Fail.

Amazin guys, thanks for the tips i will give it a try! Matt.

It dont move around much its bust very very low! it can some times scrape on speed bumps if imnot careful, and that's if i slow to about 2mph! back the the unevenness, would rewedding the back box fix the issue?

This is the thing, when i brought it, it was already installed! iv had a mate look at it but he failed. Should the centre pipe be near flush with the underside? If so i might just get a Milltek and get it fitted properly Matt

1. Jaffa182 2. whatisjustis 3. John.med 4. Cupster 5. Clairemae 6. 182kev 7. martynrg 8. kevin.s 9. CupDude 10. koi 11. xzibit 12. Bash 13. Chrisjk 14. MadHops87 15. Nigel 16. Roy Munson 17. Sean Blakey 18. RRTT 19. 182laney 20. Pete_Cup 21. The Stig 22. Weebaws 23. J88NES 24. martandem 25. Mr J...

I live in Giltbrook! I have seen a white 197 about that i flash but get blacked:(

I have a JANSpeed Cat Back system installed but my tail Pipes are uneven and the hole system looks like its hanging down too far!! The Left pipe is about 1cm lower then the right one and the right one is nearly touching the bumper.. Does anyone have any idea on how to fix the wonkyness as...

thanks again mate, fogive my Dumbness but what does changing your cams do? and i take it this is quite a large job? sorry my knowladge of engines is shocking! more of a computer man lol