Recent content by modonnell

Just had my rear pads & discs changed and have noticed that the ABS seems to kick in much more easily then before. The New discs came with the ABS rings attached. Any suggestions? And should a light come on, on the dash, if ABS is activated? Thanks Mat. PS. Clio 172 PH 1

I am having trouble access the following information: http://www.cliosport.net/forum/showthread.php?t=107873 "you do not have permission to access this page", has this become a member only page? Thanks Mat.

Is there any reason on a Mapped Clio 172 why the Ambient air sensor need to be unattached? Car was failing MOT on emissions, and the mechanic said the Ambient air sensor was unplugged. Plugging it back in caused it to run very rich and fail the emissions test even worse. Mat.

I now this might be a strange questions, but are bucket seats or reclining bucket seats compatible with baby seats? Mat.

Will get a photo at lunch and then people can see if it is too much! Mat.

Fitted some eibach pro's to my Ph1 172 a while back. The rear wheels seem to have quite some negative camber on them now. Was wondering how much was normal(anyone got a photo of theres so I can compare) and do I need to/how easy is it to sort it out? Thanks Mat.

They look pretty good in your car? They better than the standard renault seats for holding you in place? Mat.

So, where do I need to drill? Are there any location that I can use the eye bolts or will it need to be three new holes? Thanks Mat. PS. If it makes a difference this is for a 3 point harness.

Hi, looking at getting a snap-in harness for the occasional track day as I find in fast right hand corners I have to hold myself into the seat using the steering wheel. Just two quick questions: 1) Is it possible to fit the eye bolts to existing locations(i.e. No drilling required)? 2) And if...

No I cant get there from work which is a bit of a pain. There normally pretty trustworthy and they normally show me any extra work they have had to do so ill have a look when I get down there later this evening. Did a quick search on the forum and there was one message that said it was...

Garage is currently fitting my Moquip hoses to my 172(ph1) and says the support brackets need to be filed out to fit the hoses through. I spoke to Andy and he says he has not heard of this before, anyone else had this problem? Thanks Mat.

Tried everythink, heating, whacking, screwing, humping! In the end drove it down the local garage and it was stuck in good and proper so it was attacked with a drill bit. On too me next issue on the other side the rubber protecting the piston is not attached proper so the piston is not...

So those two torx builts, the ones through the disc, is there a trick to getting them off or will I need to find a freindly mechnic? I had everything off but the disc and can not get the torx bolts undone? Thanks Mat.

Maybe I should have said that I was changing the disks? Mat.

Looking for a quide to changing front brakes. I looked in the quide section and there is not one there or I missed it. Also is there a quide to changing the brake lines? Thanks Mat. PS. Its a 172 Ph1