Recent content by moktabe

These are good, will do custom as well if not on their site. https://www.isaydingdong.co.uk/

Detailer reversing it into his unit where it then lived for 2 weeks....and yes, a brake light is out.

It's been in the detailers for 2 weeks and came out today....finished! 2 miles later it's sat in my garage until I can use it but at least it's home.

Speakers up (y)

Peels MotorKraft.

About ready for coming home...

In for the wrap next week then, after 4 months, it'll be home!

Lowish revs as cold engine. Suitably mad.

Exhaust tips? Who needs them? With the pipework going from 1.75" to 3" it made things a bit tight so, no tips needed. All that remains is for new wheel studs fitting, rear spoiler refitting and the wrap to go back on and it'll be on its way back.

Things have moved along a bit The glass is now back in Exhaust work is getting sorted, the initial idea was to do away with the exit pipes from the ends of the backbox and bring them straight out of the back however, room was going to be the issue as the tailpipes would have been sticking too...

A way to go yet but it gives the idea. Exhaust is all stainless including the pipes so will clean up nicely. Although the back box may yet be covered with a plain sheet of stainless.

Mate, never took it as a bad thing in any way.

I can't crouch down that low what with getting on a bit. Well I suppose I could but getting up again would be the fun part.

It is what it is (y)

That's what they started with, a MK2 body shell then stuck bits on (y)