Recent content by Paul R

I am looking into the same thing, I will get re-mapped with 182 Injectors and a larger fmic or duct the original, already have a 165mm long trumpet to the turbo and an itg air filter, I would want over 130bhp from it. I have seen these engines with 150bhp with a stock turbo, tubular manifold...

Looking for some for my daily, its on -35 apex at the moment the rear ride height is perfect but the front looks to high, has anyone got any picks of theirs on -45 springs and info on the ride characteristics.

looks like H&R springs are on my shopping list then. i have my 15x7 et 20 and 15x8 et 20 wheels arriving soon and need to dump the front a little more and fit new Vectra splitter for the fake lows/mpg :-D

has anyone got pics of -45 mm lo-suspension or H&R setup on 15's or 16's. i have -35mm apex springs atm, rear is low as anything front is way to heigh. needs to go lower but don't want to buy the springs if they are about the same as mine. car will be running on extreme offset wheels in august...

evening all, i am getting some wheels custom made for my clio mk3 narrow arch, it is currently sitting -35mm on apex springs but the rear looks loads lower than the front which i hate. has anyone got pics of the front end of a mk3 with -45mm springs? cheers paul

Why spend 500 if you can spend 200? Simple. no question is a daft question.

is it possible to run mk2 coilovers on a mk3? or some from say a 207 or something similar?

Cool cheers for that :-)

Mk3 steel wheels fit fine on a 172, I have a set of 4 which I would swap for 15" 172 alloys ;-)

Mines got the bov blocked and a home made itg air intake, reflective heat wrapped boost pipes (free from work). Made a difference on pick up but really needs remapping properly. Exhaust wise there is a tubular manifold for the tce out there, 2.5" systems de-cats and more. Change the ic for a...

Thank you for the quick reply, I will message chip in abit and is that mad performance or engineeering?

I am on the hunt for two 30mm hub centric spacers but cannot find any anywhere in 4x100 60.1cb anyone know where to get some from? And before I get told about wheel bearings ect dont care :-). Its to finish my fuel saving mods off :-).

Use an angle grinder with a wire wheel, then finish it off with a dremel style gizmo, £30 pounds total. And re-useable for anything else you may have as well. This is how I did my mini hubs.

So basically your a wizzard? Did you go to hogwarts and s**t? Did you need to adjust the camber on your broom stick for quidich?

Ask my girlfriend? What makes you think i have one? Why do people always think you have to speed to have fun? I drag race and I do track days occasionally I have fun on national speed limit roads which are twisty and demanding. So yes I can corner faster but I can also corner with more feel...