Recent content by richydee

I used turtle wax hybrid wax to seal and protect them! gave them 3 coats so we'll see how that goes.

I used turtle wax hybrid wax to seal and protect them! gave them 3 coats so we'll see how that goes.

Finally got round to de-clouding the headlights! Turned out pretty good 👍 I used turtle wax hybrid correction wax with a course buff pad on DA polisher then turtle wax finishing wax to seal 😁 She also got full clean polish and waxed

Didn't wash the bay, engine turns over fine, will need to check immobiliser light🤔 (should it be on or off when keys in ijnition) EML on p0303 error which I've cleared using my obd reader.

Just got the dreaded 0303 code 😒 car was running fine, gave it a clean today and when i went to start it, it crancked over 3/4 times then just stopped trying to start. Engine is still turning over fine but wont fire🤔

Spend 4 hrs cleaning, machine polishing and waxing my temperamental french b**ch 😂 only for her not to start up 😢. Got error p0303 on my little cheap OBD reader, this code is saying misfire on cylinder 3, doesn't the car need to be running for the misfire to occur? Car was running great until...

All of a sudden my drivers door is out of alignment, seems to have dropped down a little :( Does anyone know how to adjust the door? I,ve seen post saying to adjust the latch on the B pillar but its definitely the door that off.

Can anyone tell me how you disconnect the hose from the top right-hand side of the inlet manifold. Think its the throttle vacuum hose

Maybe risk the drive down, Loads of speed cameras between Perth and Gainsborough:ROFLMAO::ROFLMAO::ROFLMAO:

The project continues :D Inlet manifolds port matched and gas flowed, Throttle body bored out to 64mm and fitted with new batterfly valve, all shot blasted and then sprayed dark grey. These will be going on soon then its of for a re-map. 👍👍👍

Mixture of madcow detailing and autoglym products.....gleaming (y)(y)(y)(y)

Are you talking about the blue white and red stickers in the grill? I've got them and they'll be done when the newly port matched and gas flowed throttle body (widened to 60mm) and inlet manifolds are painted and fitted...ongoing project :ROFLMAO::ROFLMAO:

Not a scratch to be seen

My titanium 182 :love: