Search results

I don't think NK are 1b listed though, just the retread

Velocity would be lower but cfm would be higher, I wondered if the larger port would compensate for the lower velocity air where the port was dimpled around the valve stem area and so improving overall flow

Did port size make any difference, Say Making the port 2mm oversize to compensate for the slower air velocity?

You look taller in other photos

^^^ That basically, D24 = VW engine in your car 10mm plunger = ultimately how much fuel the pump can deliver Daf 45 = 7.5 ton lorry made in Holland 6BT = Engine fitted to above...

I think these D24's Pump's had a 10mm Plunger anyway Craig, If you want serious amount of coal bolt on the pump from the DAF 45 / Leyland Roadrunner which were fitted with the cummins 6bt they were a Bosch VE and were 6 pot.

This will come in handy, It's the most comprehensive VE pump article http://dodgeram.org/tech/dsl/more_power/Power_ve.htm

Bosch pump tweaked yet ?

Top money saving tip: When the weather gets too cold to run Veg oil, thin it down with red diesel :up: ___________ :car:________:policecar::policecar::policecar::policecar::policecar:________ what fuel pump do these run? Bosch?

May be of use in the future Volvo 700 and 900 series scheduled services Volvo 740 1990+ and 940 engine identification Volvo 740 & 940 basic testing procedure Volvo 740 & 940 troubleshooting & system diagnosis without fault codes

It's a good box the 46, and you get to push a button when you want to go faster, which has got to be worth 100 scene points

4 speed with overdrive ?

There's a 240 with a b20 in at 'u-pull it' if you need to rob some engine sensors etc

I'd be more concerned by the lower ball joint pinch bolt that's not fully home

i have a couple of stainless back boxes that will do the job, you can have them as i was only going to scrap them. Both 2 3/4” iirc

Cup spec doesn't have seat air bags but most testers wouldn't have the product knowledge to know about the belt tensioners

you'll be fine, you can have a buckets and harness on their own, just don't remove air bags

No