Search results

you should find it easy to fit but you'll need the tracking and camber checked after. i've had mine for wellover 2 years now and there still going well

i got this but does really need a decent aeriel

here?

yeah a dc clampmeter would be the best way to measure

logitech is also a good make had the z-2200's and there good for 200wRMS

yeah there called blind grommets your going to need like a 12mm one

yeah mine tend to wear out before they go flat lol

when they look a bit flat

mines lowered about 55mm with ET35 offset 17"s with only slight rubbing if i throw it into a roundabout to quick lol

seen it on NTL on demand but never used it lol

oh yeah i've done that before aswell lol mine was cos in the middle of the m4 lmao

oh yeah i just ordered a 5w K2 luxeon star & buckpuck 1000mA driver might see if i can get that in the interiour light

if your going to get something get these their white but bright as f**k

plasma tv's use the same technology as flourecent lights so yeah they will die. as everyone has seen them go black on the ends?

the amp will never go to dc. it will send out a square wave that is still ac but will contain more power as the tansistors will be in a full on state for longer. as for having an amp with a higher output than the speaker input. yes it is ideal but your not going to blow a speaker by only gving...

what have you got the hu on? have you connected it to the sub pre out?

have you got a lpf enabled on the amp? also have you got the gain set right? also those figures you quoted mean nothing as they are not rms

your can get 46" lcds at full 1920x1080 res id choose a lcd over a plasma anyday are plasma panels using more that 1024x768 now?

this should work if you don't got a scart on the vcr

ticking isn't from the alt, that would be a wirring noise with engine speed. i'd have a check make sure your phono's are plugged properly into the hu. if it's all ok then check the settings on the amp. if all else fails ditch the amp and cap and get a new amp