Search results

inside cover of the service book normally iirc

i got a 2002 clio and sorted the passenger side and the lights went off for a while now come back on could the drivers side be at fault???

yeah they are the same as the k-tec led ones

i'm in cwmbran dianosis was a typo lol which lights? the rears?

yeah but i've seen cables grounded to bare metal but still not a good connection. well what else can you do apart from a remote dianosis(well he is only about 15 miles from me but thats besides the point)? copy and paste something from another forum?

yeah i'd say it would either be a bad earth(most likely) or a stray wire somewhere

i'd say sq that has a lot of headroom i also like RMS;)

in that H7 pack it looks like you get a set of side light "bulbs" aswell as you look at the lights you'll have your H7 dipped in the one round reflector nearest the outside then your main beam and side lights in the one next to the grill

don't listen to the monkies in halfords even if it did have the same connector probably still would be compatable sorry

you will need a H7 fitment for your dipped beam and H1 for your main beam iirc

your new hu won't work with the old changer

check all your earths make sure they aint corroded

photoshop? as i know the same leds light the numbers and needles

good effort:approve:

well i wouldn't advise using the amp remote as the supply of power to the leds use it to supply a small relay through the switch

lol i 'd just stick with the seperate earth cos the ISO earth could go anywhere knowing the french

lol RichMcc doesn't seem to far from you sure he'll do it if you cross his palm with silver

looks like you could of done with some wider angle leds in your clock but other than that top job

yeah i thought that too but has probably been moderated but yeah get the fk fixed damping ones

yeah go for the fixed damping fk coilovers:approve:

you might be able to get them here this is where i got mine from for the dials

looks much better now never been fussed with black wheels on a black car

here's mine in white but they are smt leds not your run of the mill 5mm ones

mintex pads will be at fault get something else

i really do need to get out more:o

might be able to take it apart and find out what looks busted(if it's out of warranty)

so it's 1 ohm stereo stable too lol so your getting about 600wRMS from the rear channels bridged?

you'll need a set of 5 1/4 inch(13 cm) comps for the front and yes you could run the fronts and a set of 6x9's off a two channel amp(if both the fronts and 6x9's were 4 ohms) but don't bother with 6x9's there poo

come on now being an electrician you should know the difference between resistance and impeadance but yeah if the amp goes into protection with no load connected it's probably fucked