Search results

Re: may take a couple of days fitting disks pads and service gonna get hot and sweaty This^^^ then put wheels back on and leave overnight

Respray only! the above ideas won't work.and if the spray shop say there will be a colour match problem afterwards then they are not a good body shop imo! I had the same last year but the boot was done also. they resprayed the door ,rear quarter,boot and blew it in to the front wing and tbh i...

Leave them on :D

Re: Advice on first service and recommendation of independent or specialists in Berks ^^What Steve said;)

Either put up with it being on or take the pre cat lambda sensor out and tie it up under the car and bung the hole with a suitable bolt. Then get a code reader plugged in to reset it and it won't come on again if you have done the above

Treated it like a works van!

Birchdown in malpas

its a common and normal thing with these boxes and personally don't worry about it unless it gets considerably worse.

No it shouldn't have been replaced when the belts was changed unless it is requested to be done. Another belts off job and circa 7hrs labour iirc

Nice

looking very smart. one of the cleanest/immaculate arctic clios i have seen !!

Very nice

You don't need both

Try the wheel specialist also. if you speak to mr btm he may sort a good price for you as he knows them well.

Hankooks are really bad in the wet and thats not driving like a tool either. and the budgets are also better in the wet!!

^^^This and good luck finding some

iirc city powder coating only have generic colours and don't mix paints to suit paint codes. don't hold me to it though.:)

No that shall be fine

lol dat's good innit:nono:

Video needed;)

Yeh they most likely haven't got the new ones positioned correctly which is causing it to knock against something! oOr they forgot to tighten something back up.

They will fit but may well rub the rear arch liner! well they do on my dci

Mine doesn't vibrate on idle

Miss aligned engine thats if you are on about engine/gearbox mounts.

I think it will fit but the ampage may be different dependant on what spec its come from going too

Yep they are upside down in the picture but anyone with a bit of common sense should notice when assembling. bearing always goes flat side down

Shame!!

This is the order then Silver cup bearing rubber mount big nut with spacer fit strut back in position on car top hat (far left of pic) then the other nut(bottom left of pic) ;)

Yes it is well worth it!!

I swapped my wheels round today so the hankooks are on the rear and some budgets are now up front.. And i can honestly say the budgets are so much better than them crap hankooks!! Shall not be buying hankook v12's again! the walls are too soft and just don't fill me with confidence when...