Search results

http://www.renault.co.uk/TunePoint.aspx

wardy 182 - Like MrBillyUk says, press the top of the switch for cruise control and the bottom of the switch for speed limiter, when you press either the top or bottom of the switch it should stay in on its own, you should not have to hold it in, if it pops back out to the central posistion...

.

Maz - Here is a guide of how to adjust the brake light switch, which when not adjusted properly/faulty can bring on your ABS, ESP and SERV light, also your CC may not work(green light not illuminating) - The brake light switch is located at the top of the brake pedal lever, open your...

It should say on the V5C in the 'special notes' section on the front page whether the car is an import or not, also some details such as engine number may be missing from the 'vehicle details' section. Or just ring renault and ask them - 08000 723 372

Did the owner look like his reg plate:clown:

You done well getting that lot for £1k, all the 225 BAM engines i have found have been around the £2k mark!.

^ I think that is normal as i have just checked mine and it does the same, it also flashes up the ABS light, Renault could be right in that it is doing a self check, the lights flash up briefly as you turn the key to the start posistion, i tried it several times and the first time i tried it...

The oil leak is most likely the cam cover seal, the cam cover is sealed using silicon sealant, no gasket iirc, what it appears to me is that when the seal fails (or never sealed properly in the first place) small amounts of oil can pass from inside the cam cover into the bolt holes for the cam...

Check your brake pad thickness aswell.

Nooooo, don't let them put it through the swirlomatic.

If this fault has only just happened since fitting the new bulbs, then make sure you have correctly fitted the right type of bulbs, i think they are combined stop/taillight double contact and the wiring to the light units is ok.

Sounds a bit fishy to me, a Renault dealer now offering to do £500 worth of work FOC on car that is out of warranty.

Have a go at adjusting the brake switch yourself as it may save you a trip to the dealers - The brake light switch is located at the top of the brake pedal lever, open your drivers door, get down on the floor on your knees, make sure car is out of gear and start engine (which will allow the...

You don't say what car you have but i am assuming it is a 182, the alarm does not make any bleeps to confirm it has been armed, if you are too quick on arming the alarm after switching the ignition off, the vehicle ecu signals the alarm and tells it the ignition is on and beeps, this signal is...

When i went on an airbag course they claimed static from your fingers if you touched the airbag electrical contacts *could* set them off, i used to always cut a piece of electrical tape off, then when i have removed the airbag place the tape over the contacts that were in a recess. When...

Try this guide -

Does the ABS or serv light come on aswell?, and does your cruise control stop working?, if so it will more than likely be the brake light switch needs adjusting or is faulty.

Ring Renault Customer services and quote your VIN number - 08000 723 372

http://www.cliosport.net/forum/showthread.php?t=264251

I am sure the brake servo is protected behind the bulkhead heatshield, has anything happened to the heatshield?.

http://www.cliosport.net/forum/showthread.php?t=107873

Now if you had put a bag around the reservoir, then brake fluid would probably not have sprayed everywhere in the engine bay because you did not fit the cap on the reservoir properly.:rasp:

Try adjusting it first and see what happens - The brake switch is located at the top of the brake pedal lever, open your drivers door, get down on the floor on your knees, make sure car is out of gear and start engine (which will allow the brake pedal to travel further down because the servo...

There are 2 ways to flash the bios, the first is using a windows based bios flash program that comes on your motherboard driver disc, the second is by downloading the bios update file from your motherboard manufacturer, putting the file with basic boot instructions and an installer utillity such...

I am pretty sure that when i first installed an sata drive on my now old Abit NF7-S V2.0, i had to F6 and install drivers from a floppy for the HDD when installing XP, i am pretty sure the HDD was picked up in the boot post screen but did not appear in the bios screen, the XP installation did...

My brother carried out an oil and filters change on his mates 172, not sure what age the car is though, and i think he said it was an import aswell, but his mate said that his passenger window does not go up/down off any of the window buttons and when he switches his interior light on it does...

http://www.adobe.com/support/flashplayer/downloads.html Download and run the flash player uninstaller at the bottom of the page, then re-install the latest version of the flash and shockwave player. http://www.adobe.com/shockwave/download/download.cgi?P1_Prod_Version=ShockwaveFlash...

AFAIK the remote central locking and the immobiliser are 2 seperate systems that do not share any codes, the remote unlocking/locking works using the RF PLIP part of the key and the immobiliser de-activation works by the transponder chip in the key being recognized when the key is in the...